參數資料
型號: 3820
廠商: Mitsubishi Electric Corporation
英文描述: SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
中文描述: 單芯片8位CMOS微機
文件頁數: 23/66頁
文件大?。?/td> 1093K
代理商: 3820
23
MITSUBISHI MICROCOMPUTERS
3820 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
Timer Y
Timer Y is a 16-bit timer that can be selected in one of four modes.
Timer mode
The timer counts f(X
IN
)/16 (or f(X
CIN
)/16 in low-speed mode).
Period measurement mode
CNTR
1
interrupt request is generated at rising/falling edge of
CNTR
1
pin input signal. Simultaneously, the value in timer Y latch
is reloaded in timer Y and timer Y continues counting down. /Ex-
cept for the above-mentioned, the operation in period measure-
ment mode is the same as in timer mode.
The timer value just before the reloading at rising/falling of CNTR
1
pin input signal is retained until the timer Y is read once after the
reload.
The rising/falling timing of CNTR
1
pin input signal is found by
CNTR
1
interrupt. When using a timer in this mode, set the corre-
sponding port P5
5
direction register to input mode.
Event counter mode
The timer counts signals input through the CNTR
1
pin.
Except for this, the operation in event counter mode is the same
as in timer mode. When using a timer in this mode, set the corre-
sponding port P5
5
direction register to input mode.
Pulse width HL continuously measurement mode
CNTR
1
interrupt request is generated at both rising and falling
edges of CNTR
1
pin input signal. Except for this, the operation in
pulse width HL continuously measurement mode is the same as in
period measurement mode. When using a timer in this mode, set
the corresponding port P5
5
direction register to input mode.
Note on CNTR
1
Interrupt Active Edge Selec-
tion
CNTR
1
interrupt active edge depends on the CNTR
1
active edge
switch bit. However, in pulse width HL continuously measurement
mode, CNTR
1
interrupt request is generated at both rising and
falling edges of CNTR
1
pin input signal regardless of the setting of
CNTR
1
active edge switch bit.
Fig. 13 Structure of timer Y mode register
Timer Y mode register
(TYM : address 0028
16
)
Not used (return "0" when read)
Timer Y operating mode bits
b5 b4
0 0 : Timer mode
0 1 : Period measurement mode
1 0 : Event counter mode
1 1 : Pulse width HL continuously
measurement mode
CNTR
1
active edge switch bit
CNTR
1
interrupt
0 : Falling edge active
1 : Rising edge active
Period measurement mode
0 : Measure falling edge to falling edge
1 : Measure rising edge to rising edge
Event counter mode
0 : Rising edge active
1 : Falling edge active
Timer Y stop control bit
0 : Count start
1 : Count stop
7
0
相關PDF資料
PDF描述
383-2UBC 5.0mm Round Type LED Lamps
383-2UBC-C470 5.0mm Round Type LED Lamps
3832 300mA LDO Linear Regulators with Internal Microprocessor Reset Circuit
3842B HIGH-PERFORMANCE CURRENT-MODE PWM CONTROLLERS
3842GM GREEN MODE PWM CONTROLLER
相關代理商/技術參數
參數描述
3820 AS 制造商:Ck Tools 功能描述:Bulk
3820_03 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:8-BIT SINGLE-CHIP MICROCOMPUTER
382000 功能描述:測試引線 VOLTAGE TEST LEADS W/ALLIGATOR CLIPS RoHS:否 制造商:Pomona Electronics 設備類型:Patch Cords 連接器類型:Banana plug (stackable) on both ends 長度:60 in 顏色:Black
38200-0000-00-1 制造商:Kontron 功能描述:ETXEXPRESS EVAL TYPE 3 BOARD W/ GIGE - Boxed Product (Development Kits)
382-0004 功能描述:螺絲刀、螺母起子和套筒扳手 KNURLED NUT DRIVER TOOL 4mm RoHS:否 制造商:Wiha 產品: 類型:Wiha Magic Ring Ball End Hex Keys 大小: