- 您現在的位置：買賣IC網 > PDF目錄368961 > 28LV011RT2FS-20 (MAXWELL TECHNOLOGIES) PN Series Box Enclosure; NEMA Type:1, 2, 4, 4X, 12, 13; Enclosure Material:Polycarbonate; External Height:3.54"; External Width:6.3"; External Depth:9.45"; Enclosure Color:Gray PDF資料下載
參數資料
| 型號： | 28LV011RT2FS-20 |
| 廠商： | MAXWELL TECHNOLOGIES |
| 元件分類： | PROM |
| 英文描述： | PN Series Box Enclosure; NEMA Type:1, 2, 4, 4X, 12, 13; Enclosure Material:Polycarbonate; External Height:3.54"; External Width:6.3"; External Depth:9.45"; Enclosure Color:Gray |
| 中文描述： | 128K X 8 EEPROM 3V, 200 ns, DFP32 |
| 封裝： | LDFP-32 |
| 文件頁數： | 16/19頁 |
| 文件大小： | 305K |
| 代理商： | 28LV011RT2FS-20 |
M
16
All data sheets are subject to change without notice
2002 Maxwell Technologies
All rights reserved.
3.3V 1 Megabit (128K x 8-Bit) EEPROM
28LV011
05.28.02 Rev 2
When V
CC
is turned on or off, noise on the control pins generated by external circuits, such as CPUs, may turn the EEPROMto
programmng mode by mstake. To prevent this unintentional programmng, the EEPROMmust be kept in unprogrammable
state during V
CC
on/off by using a CPU reset signal to RES pin.
RES should be kept at V
SS
level when V
CC
is turned on or off. The EEPROMbreaks off programmng operation when RES
become low programmng operation doesnt finish correctly in case that RES falls low during programmng operation. RES
should be kept high for 10 ms after the last data input.
3. Software Data Protection
The software data protection function is to prevent unintentional programmng caused by noise generated by external circuits.
In software data protection mode, 3 bytes of data must be input before write data as follows. These bytes can switch the non-
protection mode to the protection mode.
Software data protection mode can be canceled by inputting the following 6 bytes. Then, the EEPROMturns to the non-protec-
tion mode and can write data normally. However, when the data is input in the canceling cycle, the data cannot be written.
相關PDF資料 |
PDF描述 |
|---|---|
| 28LV011RT2FS-25 | 3.3V 1 Megabit (128K x 8-Bit) EEPROM |
| 28LV011RT4FB-25 | 3.3V 1 Megabit (128K x 8-Bit) EEPROM |
| 28LV011RT4FE-20 | 3.3V 1 Megabit (128K x 8-Bit) EEPROM |
| 28LV011RT4FE-25 | 3.3V 1 Megabit (128K x 8-Bit) EEPROM |
| 28LV011RT4FI-20 | 3.3V 1 Megabit (128K x 8-Bit) EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 28LV011RT2FS-25 | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:3.3V 1 Megabit (128K x 8-Bit) EEPROM |
| 28LV011RT4FB-20 | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:3.3V 1 Megabit (128K x 8-Bit) EEPROM |
| 28LV011RT4FB-25 | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:3.3V 1 Megabit (128K x 8-Bit) EEPROM |
| 28LV011RT4FE-20 | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:3.3V 1 Megabit (128K x 8-Bit) EEPROM |
| 28LV011RT4FE-25 | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:3.3V 1 Megabit (128K x 8-Bit) EEPROM |
發布緊急采購，3分鐘左右您將得到回復。