- 您現在的位置：買賣IC網 > PDF目錄246271 > 1N5932BRL (MOTOROLA INC) 20 V, 1 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-41 PDF資料下載
參數資料
| 型號： | 1N5932BRL |
| 廠商： | MOTOROLA INC |
| 元件分類： | 參考電壓二極管 |
| 英文描述： | 20 V, 1 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-41 |
| 文件頁數： | 3/5頁 |
| 文件大小： | 57K |
| 代理商： | 1N5932BRL |
GENERAL DATA — 500 mW DO-35 GLASS
Motorola TVS/Zener Device Data
6-3
500 mW DO-35 Glass Data Sheet
t, TIME (SECONDS)
0.0001 0.0002
0.0005
0.001
0.002
0.005
0.01
0.02
0.05
0.1
0.2
0.5
1
2
5
10
0.3
0.5
0.7
1
2
3
5
7
10
20
30
D =0.5
0.2
0.1
0.05
0.01
D = 0
DUTY CYCLE, D =t1/t2
θ JL
(t,
D)
TRANSIENT
THERMAL
RESIST
ANCE
JUNCTION-T
O-LEAD
(
C/W)
°
PPK
t1
NOTE: BELOW 0.1 SECOND, THERMAL
RESPONSE CURVE IS APPLICABLE
TO ANY LEAD LENGTH (L).
SINGLE PULSE
TJL = θJL (t)PPK
REPETITIVE PULSES
TJL = θJL (t,D)PPK
t2
0.02
10
20
30
50
100
200
300
500
1K
0.1
0.2 0.3 0.5
1
2
3
5
10
20 30 50
100
PW, PULSE WIDTH (ms)
P
,PEAK
SURGE
POWER
(W
A
TTS)
PK
1
2
5
10
20
50
100
200
400
1000
0.0003
0.0005
0.001
0.002
0.005
0.01
0.02
0.05
0.1
0.2
0.5
1
2
3
TA = 125°C
NOMINAL VZ (VOLTS)
AS
SPECIFIED
IN
ELEC.
CHAR.
TABLE
Figure 2. Typical Thermal Response L, Lead Length = 3/8 Inch
Figure 3. Maximum Surge Power
Figure 4. Typical Reverse Leakage
I R
,REVERSE
LEAKAGE
(
Adc)
@
V
R
RECTANGULAR
NONREPETITIVE
WAVEFORM
TJ =25°C PRIOR
TO INITIAL PULSE
APPLICATION NOTE
Since the actual voltage available from a given zener diode
is temperature dependent, it is necessary to determine junc-
tion temperature under any set of operating conditions in order
to calculate its value. The following procedure is recom-
mended:
Lead Temperature, TL, should be determined from:
TL = θLA PD + TA
θLA is the lead-to-ambient thermal resistance (°C/W) and
PD is the power dissipation. The value for θLA will vary and
depends on the device mounting method.
θLA is generally
30–40
°C/W for the various clips and tie points in common
use and for printed circuit board wiring.
The temperature of the lead can also be measured using a
thermocouple placed on the lead as close as possible to the tie
point. The thermal mass connected to the tie point is normally
large enough so that it will not significantly respond to heat
surges generated in the diode as a result of pulsed operation
once steady-state conditions are achieved. Using the mea-
sured value of TL, the junction temperature may be deter-
mined by:
TJ = TL + TJL
TJL is the increase in junction temperature above the lead
temperature and may be found from Figure 2 for a train of
power pulses (L = 3/8 inch) or from Figure 10 for dc power.
TJL = θJL PD
For worst-case design, using expected limits of IZ, limits of
PD and the extremes of TJ (TJ) may be estimated. Changes
in voltage, VZ, can then be found from:
V = θVZ TJ
θVZ,thezenervoltagetemperaturecoefficient,isfoundfrom
Figures 5 and 6.
Under high power-pulse operation, the zener voltage will
vary with time and may also be affected significantly by the
zener resistance. For best regulation, keep current excursions
as low as possible.
Data of Figure 2 should not be used to compute surge capa-
bility. Surge limitations are given in Figure 3. They are lower
than would be expected by considering only junction tempera-
ture, as current crowding effects cause temperatures to be ex-
tremely high in small spots resulting in device degradation
should the limits of Figure 3 be exceeded.
相關PDF資料 |
PDF描述 |
|---|---|
| 1N4758A | 56 V, 1 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-41 |
| 1N823-1 | 6.2 V, SILICON, VOLTAGE REFERENCE DIODE, DO-35 |
| 1N825 | 6.2 V, SILICON, VOLTAGE REFERENCE DIODE, DO-35 |
| 1N937B-1 | 9 V, SILICON, VOLTAGE REFERENCE DIODE, DO-35 |
| 1N4060 | 18.5 V, SILICON, VOLTAGE REFERENCE DIODE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 1N5932BRLG | 功能描述:穩壓二極管 20V 3W RoHS:否 制造商:Vishay Semiconductors 齊納電壓:12 V 電壓容差:5 % 電壓溫度系數:0.075 % / K 齊納電流: 功率耗散:3 W 最大反向漏泄電流:3 uA 最大齊納阻抗:7 Ohms 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AC 封裝:Reel |
| 1N5932BRNG | 功能描述:穩壓二極管 RoHS:否 制造商:Vishay Semiconductors 齊納電壓:12 V 電壓容差:5 % 電壓溫度系數:0.075 % / K 齊納電流: 功率耗散:3 W 最大反向漏泄電流:3 uA 最大齊納阻抗:7 Ohms 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AC 封裝:Reel |
| 1N5932B-TP | 制造商:Micro Commercial Components (MCC) 功能描述:Diode Zener Single 20V 5% 1.5W 2-Pin DO-41G T/R |
| 1N5932BUR-1 | 制造商:Microsemi Corporation 功能描述:ZENER SGL 20V 5% 1.25W 2PIN DO-213AB - Bulk |
| 1N5932C | 功能描述:Zener Diode 制造商:microsemi corporation 系列:* 零件狀態:在售 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。