- 您現在的位置：買賣IC網 > PDF目錄106294 > 110IMY15-05-8RIL (POWER-ONE INC) 1-OUTPUT 12.8 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | 110IMY15-05-8RIL |
| 廠商： | POWER-ONE INC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 12.8 W DC-DC REG PWR SUPPLY MODULE |
| 文件頁數： | 11/20頁 |
| 文件大?。?/td> | 303K |
| 代理商： | 110IMY15-05-8RIL |
Board Mountable
DC-DC Converters
IMX/IMY 15 Series
Edition 7/5.2000
19/20
Table 17: Insulation concept leading to an SELV output circuit
Conditions
Front end
DC-DC converter
Result
Supply
Minimum required grade
Maximum
Minimum required
Type
Measures to achieve the
Safety status of
voltage
of isolation, to be provided DC output
safety status of the
specified safety status of
the DC-DC
by the AC-DC front end,
voltage
front end output
the output circuit
converter output
including mains supplied
from the
circuit
battery charger
front end 1
Mains
Operational (i.e. there is
≤150 V
Primary
IMY 15
Double or reinforced
SELV circuit
≤150 V AC no need for electrical iso-
insulation, based on
lation between the mains
150 V AC and DC (pro-
supply voltage and the
vided by the DC-DC
DC-DC converter input
converter)
voltage)
Mains
Basic
≤60 V
Earthed SELV circuit 2 IMX 15
Operational insulation
≤250 V AC
IMY 15
(provided by the DC-DC
converter)
≤75 V
Hazardous voltage
IMX 15
Input fuse 3 output sup-
Earthed SELV
secondary circuit
pressor diodes 4, and
circuit
earthed output circuit 2
≤150 V
IMY 15
Supplementary insulation
SELV circuit
based on 250 V AC and
double or reinforced
insulation, based on the
maximum rated output
voltage from the front end
(provided by the DC-DC
converter)
Double or reinforced
≤60 V
SELV circuit
IMX 15
Operational insulation
IMY 15
(provided by the DC-DC
converter)
≤75 V
Double or reinforced
IMX 15
Supplementary insulation
insulated unearthed
based on the maximum
hazardous voltage
rated output voltage from
secondary circuit 5
the front end (provided by
the DC-DC converter)
≤120 V
TNV-2 circuit
IMY 15
Double or reinforced
≤150 V
Double or reinforced
insulation, based on the
insulated earthed or
maximum rated output
unearthed hazardous
voltage from the front end
voltage secondary
(provided by the DC-DC
circuit
converter)
Safety of operator accessible output circuit
If the output circuit of a DC-DC converter is operator acces-
sible, it shall be an SELV circuit according to the IEC/EN
60950 related safety standards
The following table shows some possible installation con-
figurations, compliance with which causes the output circuit
of the DC-DC converter to be an SELV circuit according to
IEC/EN 60950 up to a configured output voltage (sum of
nominal voltages if in series or +/– configuration) of 42 V.
However, it is the sole responsibility of the installer to en-
sure the compliance with the relevant and applicable safety
regulations. More information is given in:
Technical Infor-
mation: Safety.
1 The front end output voltage should match the specified input
voltage range of the DC-DC converter.
2 The earth connection has to be provided by the installer accord-
ing to the relevant safety standard, e.g. IEC/EN 60950.
3 The installer shall provide an approved fuse (type with the low-
est rating suitable for the application) in a non-earthed input
conductor directly at the input of the DC-DC converter (see fig.:
Schematic safety concept). For UL’s purpose, the fuse needs to
be UL-listed. See also:
Input Fuse.
4 Each suppressor diode should be dimensioned in such a way,
that in the case of an insulation fault the diode is able to limit the
output voltage to SELV (<60 V) until the input fuse blows (see
fig.:
Schematic safety concept).
5 Has to be insulated from earth by at least basic insulation ac-
cording to the relevant safety standard, based on the maximum
output voltage from the front end.
AC-DC
front
end
DC-DC
con-
verter
Mains
Fuse
Battery
Earth
connection
Suppressor
diode
SELV
Earth
connection
+
–
~
10004
Fig. 32
Schematic safety concept. Use fuse, suppressor diode
and earth connection as per table Safety concept leading
to an SELV output circuit
.
相關PDF資料 |
PDF描述 |
|---|---|
| 110IMY15-15-15-9RIZ | 2-OUTPUT 16.8 W DC-DC REG PWR SUPPLY MODULE |
| 110IMY15-24-24-9L | 2-OUTPUT 16.8 W DC-DC REG PWR SUPPLY MODULE |
| 15SM15D | 2-OUTPUT 0.625 W DC-DC UNREG PWR SUPPLY MODULE |
| 12SC5D | 2-OUTPUT 1.25 W DC-DC UNREG PWR SUPPLY MODULE |
| 110IMX7-12-12-9M | 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 110IMY15-05-9R | 制造商:POWER-ONE 制造商全稱:Power-One 功能描述:15 Watt DC-DC Converters |
| 110IMY15-05-9RG | 制造商:POWER-ONE 制造商全稱:Power-One 功能描述:15 Watt DC-DC Converters |
| 110IMY15-12-12-8 | 功能描述:DC/DC轉換器 15W (2x 12V) DC Input (60-150V) RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| 110IMY15-12-12-8G | 功能描述:DC/DC CONVERT DUAL 12V 0.7A 制造商:bel power solutions 系列:* 零件狀態:新產品 標準包裝:12 |
| 110IMY15-12-12-8-G | 功能描述:DC/DC轉換器 50 to 150VDC 0.7A 7W DC-DC CONVERTER RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。