DESCO WEST
- 3651 Walnut Avenue, Chino, CA 91710 (909) 627-8178
DESCO EAST
- One Colgate Way, Canton, MA 02021-1407 (781) 821-8370 Website: Desco.com TB-2005 Page 3 of 3
2014 DESCO INDUSTRIES, INC.
Employee Owned
Replacement of Elastic Material
number
09029 from Desco for a wristband replacement strip.
Order item number 09140 from Desco for a Jewel wristband replacement strip. When the elastic material becomes worn
out, it can be easily replaced. To replace, simply open the
clasp as described under “Adjustment”. Remove the fabric
from the clasp. Note that the second end of the material is
secured to the clasp by a smaller camlock. Open the small
camlock (A small screwdriver is helpful.) Remove the worn
wristband strip and replace it with the
09029. Be sure no
material extends to the end of the lever arm of the small
camlock. This will cause the clasp to close improperly and
not hold firmly.
Metal Expansion Wristbands
1. Insert the link end of the wristband into the slotted
opening on the cap. Insert it at a downward angle to allow
the links to slide inside the channel in the backplate.
2. Change the size of the band by sliding the links in or out
of the stainless steel backplate. For extra small users you
can cut off excess links with cutters.
3. Lock the links into place by pulling down on the band,
seating the band securely over the lip on the edge of the
backplate.
4. Test the wrist strap system to be sure of proper electrical
resistance and skin contact. Use the procedure described
under “Testing” section on reverse side.
Hook and Loop Wrist Strap
This wristband consists of a hook
and loop band with a D-ring
buckle, a conductive strip for
static charge dissipation, and
a 4mm snap stud. The D-ring
enables the wearer to cinch the
band for a secure fit. The band will adjust to
fit any size wrist. Contact with the wearer is established
through a conductive teflon tab sewn to the inside of the
band.
1. Attach wrist strap on wrist so that the black conductive
band makes contact with skin.
2. Pull strap through D-ring and cinch the band for a snug fit.
3. Test the wrist strap system to be sure of proper electrical
resistance and skin contact. Use the procedure described
under “Testing The Wrist Strap” on page 1.
Note:
Desco wrist straps and coil cords are UL Listed for
safety. However, this product is not recommended for use on
equipment with operating voltage exceeding 250 VAC.
CAUTION:
The ESD Series is for electrostatic control. It
will not reduce or increase your risk of receiving electric
shock when using or working on electrical equipment. Follow
the same precautions you would use without wrist straps,
including:
Make certain that equipment having a grounding type plug
is properly grounded.
Make certain that you are not in contact with grounded
objects other than through the ESD Series.
Limited Warranty, Warranty Exclusions, Limit of
Liability and RMA Request Instructions
See Desco’s Terms and Conditions -