參數資料
型號: μPD753104
廠商: NEC Corp.
英文描述: 4 Bit Single Chip Microcontrollers(4位單片微控制器)
中文描述: 4位單片微控制器(4位單片微控制器)
文件頁數: 60/90頁
文件大小: 419K
代理商: ΜPD753104
60
μ
PD753104, 753106, 753108
MAIN SYSTEM CLOCK OSCILLATOR CHARACTERISTICS (T
A
= –40 to +85 C, V
DD
= 1.8 to 5.5 V)
Resonator
Recommended constant
Parameter
Test conditions
MIN.
TYP.
MAX.
Unit
Ceramic
Oscillation
1.0
6.0
Note 2
MHz
resonator
frequency (fx)
Note 1
Oscillation
After V
DD
reaches oscil-
4
ms
stabilization time
Note 3
lation voltage range MIN.
Crystal
Oscillation
1.0
6.0
Note 2
MHz
resonator
frequency (fx)
Note 1
Oscillation
V
DD
= 4.5 to 5.5 V
10
ms
stabilization time
Note 3
30
External
X1 input
1.0
6.0
Note 2
MHz
clock
frequency (fx)
Note 1
X1 input
high/low-level width
(t
XH
, t
XL
)
83.3
500
ns
Notes 1.
The oscillation frequency and X1 input frequency indicate characteristics of the oscillator only. For
the instruction execution time, refer to the AC characteristics.
When the oscillation frequency is 4.19 MHz < fx
6.0 MHz at 1.8 V
V
DD
< 2.7 V, setting the processor
clock control register (PCC) to 0011 results in 1 machine cycle time being less than the required 0.95
μ
s. Therefore, set PCC to a value other than 0011.
The oscillation stabilization time is necessary for oscillation to stabilize after applying V
DD
or releasing
the STOP mode.
2.
3.
Caution
When using the main system clock oscillator, wiring in the area enclosed with the dotted line in the
above figure should be carried out as follows to avoid an adverse effect from wiring capacitance.
Wiring should be as short as possible.
Wiring should not cross other signal lines.
Wiring should not be placed close to a varying high current.
The potential of the oscillator capacitor ground should be the same as V
DD
.
Do not ground to the ground pattern in which a high current flows.
Do not fetch a signal from the oscillator.
X2
X1
C1
C2
V
DD
X2
X1
C1
C2
V
DD
X1
X2
相關PDF資料
PDF描述
μPD753106 4 Bit Single Chip Microcontrollers(4位單片微控制器)
μPD753108 4 Bit Single Chip Microcontrollers(4位單片微控制器)
μPD753204 4 Bit Single Chip Microcontrollers(4位單片微控制器)
μPD753208 4 Bit Single Chip Microcontrollers(4位單片微控制器)
μPD753206 4 Bit Single Chip Microcontrollers(4位單片微控制器)
相關代理商/技術參數
參數描述
PD75-333K 功能描述:固定電感器 33uH 10% .15ohm Choke SMT Power Ind RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm
PD75-393K 功能描述:固定電感器 39uH 10% .18ohm Choke SMT Power Ind RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm
PD75-473K 功能描述:固定電感器 47uH 10% .21ohm Choke SMT Power Ind RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm
PD75-563K 功能描述:固定電感器 56uH 10% .24ohm Choke SMT Power Ind RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm
PD75-683K 功能描述:固定電感器 68uH 10% .3ohm Choke SMT Power Ind RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm