參數資料
型號: UBA2051C
廠商: NXP Semiconductors N.V.
英文描述: One-chip telephone ICs with speech, dialler and ringer functions
中文描述: 一個有語言,撥號及振鈴電話集成電路芯片的功能
文件頁數: 29/52頁
文件大小: 292K
代理商: UBA2051C
2000 May 19
29
Philips Semiconductors
Product specification
One-chip telephone ICs with speech,
dialler and ringer functions
UBA2050(A); UBA2051(A;C)
handbook, full pagewidth
MGM347
TONE DIALLING
PULSE DIALLING
DIALLING
PTS = on
PTS = off
end
dial keys
[
*
/T] or [P->T]
[R]
+
PTS = on
CONVERSATION
Fig.30 Dialling mode state machine.
Pulse dialling
Inthismodeallvalidkeysaredialledbythepulsedialler.
When, during pulse dialling, either [
/T] when MMS is off
or [P
T] is pressed, the UBA205xx switches over to
tonedialling(mixedmodedialling).Aftertheswitchover,
valid keys are dialled by the tone dialler. The temporary
tone mode is terminated by going on-hook or flash
(Recall).
Tone dialling
The UBA205xx converts valid key entries into data for
the on-chip DTMF generator. Tones are transmitted via
output MDY/TONE with a minimum tone burst/pause
duration. The maximum tone burst duration is equal to
the key pressing time.
Flash function
The [R] key will result in pin DP/FL being set to LOW to
generate a flash (line current interruption) with a
selected time (FTSA and FTSB resistor options).
Pressing one digit after [R] key is pressed clears the
LNR memory. When going on-hook after the [R] key is
pressed, then digits previously dialled in the LNR
memory are kept.
Access pause
When the [LNR/P] button is not the first key pressed, an
access pause is entered for repertory or redialling
procedures.
Last number redial
If the first key pressed is [LNR/P], the number stored in
the LNR memory is dialled and sent. A maximum
number of 32 digits can be stored in the LNR memory.
If this maximum is exceeded the redial function is
inhibited. Pauses, which are stored in the LNR memory,
are also dialled.
The tone switch keys [
/T] (when MMS is off) and
[P
T] are also stored in the LNR memory. When a
[
/T] key (when MMS is on) or [#] key occurs during
pulse dialling, its code is not stored in the LNR memory.
The LNR memory is always cleared when the [STORE]
key is pressed. Its content may also be programmed
(see Section “Program state (only UBA2051x)”).
相關PDF資料
PDF描述
UBA2051CT One-chip telephone ICs with speech, dialler and ringer functions
UBA2051T One-chip telephone ICs with speech, dialler and ringer functions
UBA2070 8-bit MCU for automotive with 16 to 60 Kbyte Flash, ADC, CSS, 5 timers, SPI, SCI, I2C interface
UBB1000 8-bit MCU for automotive with 16 to 60 Kbyte Flash, ADC, CSS, 5 timers, SPI, SCI, I2C interface
UBC41 DUODIODE TRIODE
相關代理商/技術參數
參數描述
UBA2051CT 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:One-chip telephone ICs with speech, dialler and ringer functions
UBA2051T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:One-chip telephone ICs with speech, dialler and ringer functions
UBA2070 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:600 V CCFL ballast driver IC
UBA2070P 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:600 V CCFL ballast driver IC
UBA2070P/N1,112 功能描述:顯示驅動器和控制器 CCFL RoHS:否 制造商:Panasonic Electronic Components 工作電源電壓:2.7 V to 5.5 V 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Reel