- 您現在的位置：買賣IC網 > PDF目錄385015 > TRC102 (RF Monolithics, Inc.) 400-1000MHz RF Transceiver PDF資料下載
參數資料
| 型號： | TRC102 |
| 廠商： | RF Monolithics, Inc. |
| 英文描述： | 400-1000MHz RF Transceiver |
| 中文描述： | 400 - 1000MHz的射頻收發器 |
| 文件頁數： | 9/40頁 |
| 文件大?。?/td> | 449K |
| 代理商： | TRC102 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
9
byte character uses only SB0, which is user configurable. A word character uses both SB1 and SB0 with
the lower byte SB0 being user configurable. This becomes an advantage when operating near other
interferers or identifying specific transmitters.
Automatic Frequency Adjustment (AFA)
The PLL has the capability to do fine adjustment of the carrier frequency automatically. In this way, the
receiver can minimize the offset between transmit and receive frequency. This function may be enabled
or disabled through the
Automatic Frequency Adjustment Register
. The range of offset can be
programmed as well as the offset value calculated and added to the frequency control word within the
PLL to incrementally change the carrier frequency. The chip can be programmed to automatically
perform an adjustment or may be manually activated by a strobe signal. This function has the advantage
of allowing:
Low cost, lower accuracy crystals to be used
Increased receiver sensitivity by narrowing the receive bandwidth
Achieving higher data rates
Crystal Oscillator
The TRC102 incorporates an internal crystal oscillator circuit that provides a 10MHz reference, as well as
internal load capacitors. This significantly reduces the component count required. The internal load
capacitance is programmable from 8.5pF to 16pF in 0.5pF steps. This has the advantage of accepting a
wide range of crystals from many different manufacturers having different load capacitance requirements.
Being able to vary the load capacitance also helps with fine tuning the final carrier frequency since the
crystal is the PLL reference for the carrier.
The crystal oscillator circuit is sensitive to parasitic
capacitance for startup. Only a slight amount of parasitic capacitance is needed to facilitate oscillation. A
recommended solution is to apply a ground plane around the crystal and widen the connection to the
TRC102. If this is not possible, a 0.5-1pF capacitor soldered across the crystal will initiate startup.
An external clock signal is also provided that may be used to run an external processor. This also has
the advantage of reducing component count by eliminating an additional crystal for the host processor.
The clock frequency is also programmable from eight pre-defined frequencies, each a pre-scaled value of
the 10MHz crystal reference. These values are programmable through the
Battery Detect Threshold and
Clock Output Register
. The internal clock oscillator may be disabled which also disables the output clock
signal to the host processor. When the oscillator is disabled, the chip provides an additional 196 clock
cycles before releasing the output, which may be used by the host processor to setup any functions
before going to sleep.
Frequency Control (PLL) and Frequency Synthesizer
The PLL synthesizer is the heart of the operating frequency. It is programmable and completely
integrated, providing all functions required to generate the carriers and tunability for each band. The PLL
requires only a single 10MHz crystal reference source. RF stability is controlled by choosing a crystal
with the particular specifications to satisfy the application. This gives the designer the maximum flexibility
in performance.
The PLL is able to perform manual and automatic calibration to compensate for changes in temperature
or operating voltage. When changing band frequencies, re-calibration must be performed. This can be
done by disabling the synthesizer and re-enabling again through the
Power Management Register
.
Registers common to the PLL are:
Power Management Register
Configuration Register
Frequency Setting Register
Automatic Frequency Adjust Register
Transmit Configuration Register
Data Quality Detector (DQD)
The DQD is a unique function of the TRC102. The DQD circuit looks at the prefiltered incoming data and
counts the “spikes” of noise for a predetermined period of time to get an idea of the quality of the link.
This parameter is programmable through the
Data Filter Command Register
. The DQD count threshold is
相關PDF資料 |
PDF描述 |
|---|---|
| TRF2052 | LOW-VOLTAGE 2-GHz SYNTHESIZER |
| TRF2052PW | LOW-VOLTAGE 2-GHz SYNTHESIZER |
| TRF2432_07 | Dual-Band IQ/IF TRANSCEIVER WITH DUAL VCO SYNTHESIZERS |
| TriCore | 32-bit microcontrollers(32位微控制器) |
| TRR-8A33 | Connectorized High-speed GaAs PIN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TRC1028 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10/100M Single Port Transformer Modules |
| TRC103 | 功能描述:射頻接收器 Transceiver 868-960 MHz, Multi-chnl FSK RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| TRC1036 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10/100M Single Port Transformer Modules |
| TRC104 | 功能描述:射頻收發器 Transceiver 2.4 GHz Multi-channel GFSK RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| TRC1044 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10/100M Single Port Transformer Modules |
發布緊急采購，3分鐘左右您將得到回復。