- 您現在的位置：買賣IC網 > PDF目錄385015 > TRC102 (RF Monolithics, Inc.) 400-1000MHz RF Transceiver PDF資料下載
參數資料
| 型號： | TRC102 |
| 廠商： | RF Monolithics, Inc. |
| 英文描述： | 400-1000MHz RF Transceiver |
| 中文描述： | 400 - 1000MHz的射頻收發器 |
| 文件頁數： | 15/40頁 |
| 文件大?。?/td> | 449K |
| 代理商： | TRC102 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
15
Automatic Frequency Adjust Register
[POR=C4F7h]
Bit Bit Bit Bit Bit Bit
Bit Bit
15 14 13 12 11 10
9
1
1
0
0
0
1
0
The AFA (Automatic Frequency Adjust) Register configures:
Manual or Automatic frequency offset adjustment
Calculation of the offset value and write to the Status Register
Fine offset adjustment control
The AFA (Automatic Frequency Adjust) Register controls and configures the frequency adjustment range
and mode for keeping the transmitter and receiver frequency locked, providing for an optimal link. The
AFA may be manually controlled by an external processor by asserting a strobe signal to initiate a
sample, or may be setup for automatic operation, which uses the Valid Data Detector (VDI) signal to
initiate a frequency adjustment. When the VDI goes active, the AFA circuit performs a sample and
updates the offset register automatically. The elapsed time for an AFA is determined by the setting of the
clock recovery (CR) bit in the
Baseband Filter Register.
The AFA also calculates the offset of the transmit
and receive frequency. This offset value is included in the status register read and the AFA must be
disabled during the status read to ensure reporting good offset accuracy.
Bit [15..8] - Command Code
: These bits are the command code that is sent serially to the processor that
identifies the bits to be written to the Automatic Frequency Adjust Register.
Bit [7..6] – Mode Selection
: These bits select Automatic or Manual operation. When set to Manual
operation, the TRC102 will take a sample when a strobe signal (See Bit [3]) is written to the register.
There are four modes of operation. See Table 5 below for configuration.
TABLE 5.
Mode(0,1)
– The circuit takes a measurement only once after power-up.
Mode(1,0)
– When the Valid Data Detector (VDI) pin is low, indicating poor receiving conditions,
the offset register is automatically cleared. Use this setting when receiving from several different
transmitters that are operating very close to the same frequencies so that the receiver may align
itself on each transmission from a different transmitter.
Mode(1,1)
– This setting is best used when receiving from a single transmitter. The measured
offset value is kept independent of the state of the VDI signal. Once the link is aligned it may be
manually toggled by the user.
Bit
7
Bit
6
Bit
5
Bit
4
Bit
3
Bit
2
Bit
1
Bit
0
8
0
AUTO1
AUTO0
RNG1
RNG0
STRB ACCF OFFEN
AFEN
Automatic f
OFFSET
Mode
Mode Off
Run Once after Pwr-up
Keep offset during Rcv ONLY
Keep offset indep of VDI state
AUTO1
0
0
1
1
AUTO0
0
1
0
1
相關PDF資料 |
PDF描述 |
|---|---|
| TRF2052 | LOW-VOLTAGE 2-GHz SYNTHESIZER |
| TRF2052PW | LOW-VOLTAGE 2-GHz SYNTHESIZER |
| TRF2432_07 | Dual-Band IQ/IF TRANSCEIVER WITH DUAL VCO SYNTHESIZERS |
| TriCore | 32-bit microcontrollers(32位微控制器) |
| TRR-8A33 | Connectorized High-speed GaAs PIN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TRC1028 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10/100M Single Port Transformer Modules |
| TRC103 | 功能描述:射頻接收器 Transceiver 868-960 MHz, Multi-chnl FSK RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| TRC1036 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10/100M Single Port Transformer Modules |
| TRC104 | 功能描述:射頻收發器 Transceiver 2.4 GHz Multi-channel GFSK RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| TRC1044 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10/100M Single Port Transformer Modules |
發布緊急采購，3分鐘左右您將得到回復。