參數資料
型號: SN74AHC123ADB
廠商: Texas Instruments, Inc.
英文描述: CAP .0047UF 100V PPS FILM ECH-S
中文描述: 雙RETRIGGERABLE單穩態多頻振蕩器
文件頁數: 9/23頁
文件大?。?/td> 598K
代理商: SN74AHC123ADB
SN54AHC123A, SN74AHC123A
DUAL RETRIGGERABLE MONOSTABLE MULTIVIBRATORS
SCLS352G
JULY 1997
REVISED APRIL 2003
9
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
caution in use
To prevent malfunctions due to noise, connect a high-frequency capacitor between V
CC
and GND, and keep
the wiring between the external components and C
ext
and R
ext
/C
ext
terminals as short as possible.
power-down considerations
Large values of C
ext
can cause problems when powering down the
AHC123A devices because of the amount
of energy stored in the capacitor. When a system containing this device is powered down, the capacitor can
discharge from V
CC
through the protection diodes at pin 2 or pin 14. Current through the input protection diodes
must be limited to 30 mA; therefore, the turn-off time of the V
CC
power supply must not be faster than
t = V
CC
×
C
ext
/30 mA. For example, if V
CC
= 5 V and C
ext
= 15 pF, the V
CC
supply must turn off no faster than
t = (5 V)
×
(15 pF)/30 mA = 2.5 ns. Usually, this is not a problem because power supplies are heavily filtered
and cannot discharge at this rate. When a more rapid decrease of V
CC
to zero occurs, the
AHC123A devices
can sustain damage. To avoid this possibility, use external clamping diodes.
output pulse duration
The output pulse duration, t
w
, is determined primarily by the values of the external capacitance (C
T
) and timing
resistance (R
T
). The timing components are connected as shown in Figure 2.
VCC
RT
CT
To Rext/Cext
Terminal
To Cext
Terminal
Figure 2. Timing-Component Connections
The pulse duration is given by:
t
w
K
R
T
C
T
if C
T
is
1000 pF, K = 1.0 or
if C
T
is
<
1000 pF, K can be determined from Figure 5
where:
t
w
= pulse duration in ns
R
T
= external timing resistance in k
C
T
= external capacitance in pF
K
= multiplier factor
Equation 1 and Figure 3 can be used to determine values for pulse duration, external resistance, and external
capacitance.
(1)
相關PDF資料
PDF描述
SN54AHC123AJ DUAL RETRIGGERABLE MONOSTABLE MULTIVIBRATORS
SN54AHC123AW DUAL RETRIGGERABLE MONOSTABLE MULTIVIBRATORS
SN74AHC123ADGV DUAL RETRIGGERABLE MONOSTABLE MULTIVIBRATORS
SN74AHC123APW DUAL RETRIGGERABLE MONOSTABLE MULTIVIBRATORS
SN54AHC125FK QUADRUPLE BUS BUFFER GATES WITH 3-STATE OUTPUTS
相關代理商/技術參數
參數描述
SN74AHC123ADBR 功能描述:單穩態多諧振蕩器 Dual Retrig Mono RoHS:否 制造商:Texas Instruments 每芯片元件:1 邏輯系列:LVC 邏輯類型:Monostable Multivibrator 封裝 / 箱體:SSOP-8 傳播延遲時間:18.6 ns 高電平輸出電流:- 32 mA 低電平輸出電流:32 mA 電源電壓-最大:5.5 V 電源電壓-最小:1.65 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel
SN74AHC123ADBRE4 功能描述:單穩態多諧振蕩器 Dual retrig monostbl multivibrators RoHS:否 制造商:Texas Instruments 每芯片元件:1 邏輯系列:LVC 邏輯類型:Monostable Multivibrator 封裝 / 箱體:SSOP-8 傳播延遲時間:18.6 ns 高電平輸出電流:- 32 mA 低電平輸出電流:32 mA 電源電壓-最大:5.5 V 電源電壓-最小:1.65 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel
SN74AHC123ADBRG4 功能描述:單穩態多諧振蕩器 Dual Retriggerable Mono Multivibratr RoHS:否 制造商:Texas Instruments 每芯片元件:1 邏輯系列:LVC 邏輯類型:Monostable Multivibrator 封裝 / 箱體:SSOP-8 傳播延遲時間:18.6 ns 高電平輸出電流:- 32 mA 低電平輸出電流:32 mA 電源電壓-最大:5.5 V 電源電壓-最小:1.65 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel
SN74AHC123ADE4 功能描述:單穩態多諧振蕩器 Dual retrig monostbl multivibrators RoHS:否 制造商:Texas Instruments 每芯片元件:1 邏輯系列:LVC 邏輯類型:Monostable Multivibrator 封裝 / 箱體:SSOP-8 傳播延遲時間:18.6 ns 高電平輸出電流:- 32 mA 低電平輸出電流:32 mA 電源電壓-最大:5.5 V 電源電壓-最小:1.65 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel
SN74AHC123ADG4 功能描述:單穩態多諧振蕩器 Dual retrig monostbl multivibrators RoHS:否 制造商:Texas Instruments 每芯片元件:1 邏輯系列:LVC 邏輯類型:Monostable Multivibrator 封裝 / 箱體:SSOP-8 傳播延遲時間:18.6 ns 高電平輸出電流:- 32 mA 低電平輸出電流:32 mA 電源電壓-最大:5.5 V 電源電壓-最小:1.65 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel