參數資料
型號: SC16C654IB64,128
廠商: NXP SEMICONDUCTORS
元件分類: 微控制器/微處理器
英文描述: 4 CHANNEL(S), 5M bps, SERIAL COMM CONTROLLER, PQFP64
封裝: 10 X 10 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT-314-2, LQFP-64
文件頁數: 5/52頁
文件大?。?/td> 647K
代理商: SC16C654IB64,128
Philips Semiconductors
SC16C654/654D
Quad UART with 64-byte FIFO and infrared (IrDA) encoder/decoder
Product data
Rev. 04 — 19 June 2003
13 of 52
9397 750 11617
Koninklijke Philips Electronics N.V. 2003. All rights reserved.
6.4 Internal registers
The SC16C654/654D provides 15 internal registers for monitoring and control. These
registers are shown in Table 5. Twelve registers are similar to those already available
in the standard 16C554. These registers function as data holding registers
(THR/RHR), interrupt status and control registers (IER/ISR), a FIFO control register
(FCR), line status and control registers (LCR/LSR), modem status and control
registers (MCR/MSR), programmable data rate (clock) control registers (DLL/DLM),
and a user accessible scratchpad register (SPR). Beyond the general 16C554
features and capabilities, the SC16C654/654D offers an enhanced feature register
set (EFR, Xon/Xoff1-2) that provides on-board hardware/software ow control.
Register functions are more fully described in the following paragraphs.
[1]
These registers are accessible only when LCR[7] is a logic 0.
[2]
These registers are accessible only when LCR[7] is a logic 1.
[3]
Enhanced Feature Register, Xon1, 2 and Xoff1, 2 are accessible only when the LCR is set to
“BF” (HEX).
6.5 FIFO operation
The 64-byte transmit and receive data FIFOs are enabled by the FIFO Control
Register (FCR) bit 0. With SC16C554 devices, the user can set the receive trigger
level, but not the transmit trigger level. The SC16C654/654D provides independent
trigger levels for both receiver and transmitter. To remain compatible with SC16C554,
the transmit interrupt trigger level is set to 8 following a reset. It should be noted that
the user can set the transmit trigger levels by writing to the FCR register, but
activation will not take place until EFR[4] is set to a logic 1. The receiver FIFO section
includes a time-out function to ensure data is delivered to the external CPU. An
Table 5:
Internal registers decoding
A2
A1
A0
READ mode
WRITE mode
General register set (THR/RHR, IER/ISR, MCR/MSR, FCR, LSR, SPR)[1]
0
Receive Holding Register
Transmit Holding Register
0
1
Interrupt Enable Register
0
1
0
Interrupt Status Register
FIFO Control Register
0
1
Line Control Register
1
0
Modem Control Register
1
0
1
Line Status Register
n/a
1
0
Modem Status Register
n/a
1
Scratchpad Register
Baud rate register set (DLL/DLM)[2]
0
LSB of Divisor Latch
0
1
MSB of Divisor Latch
Enhanced register set (EFR, Xon/off 1-2)[3]
0
1
0
Enhanced Feature Register
1
0
Xon1 word
1
0
1
Xon2 word
1
0
Xoff1 word
1
Xoff2 word
相關PDF資料
PDF描述
SC16C654IA68,512 4 CHANNEL(S), 5M bps, SERIAL COMM CONTROLLER, PQCC68
SC18005CQ SPECIALTY MICROPROCESSOR CIRCUIT, PQFP144
SC18IS600IBS,151 I2C BUS CONTROLLER, PQCC24
SC18IS600IBS I2C BUS CONTROLLER, PQCC24
SC2200UCL-300 32-BIT, 300 MHz, MICROPROCESSOR, PBGA432
相關代理商/技術參數
參數描述
SC16C750 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Universal Asynchronous Receiver/Transmitter (UART) with 64-byte FIFO
SC16C750B 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:5 V, 3.3 V and 2.5 V UART with 64-byte FIFOs
SC16C750BIA44 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C750BIA44,512 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C750BIA44,518 功能描述:UART 接口集成電路 1CH. UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel