參數資料
型號: SAF-XC2785X-104F80L
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
封裝: 0.50 MM PITCH, GREEN, PLASTIC, LQFP-144
文件頁數: 124/141頁
文件大?。?/td> 1793K
代理商: SAF-XC2785X-104F80L
XC2785X
XC2000 Family / Base Line
Electrical Parameters
Data Sheet
83
V2.1, 2011-07
Absolute sum of overload
currents
Σ|I
OV|
SR
50
mA
not subject to
production test
Digital core supply voltage
for domain M
8)
V
DDIM
CC
1.5
Digital core supply voltage
for domain 1
V
DDI1
CC
1.5
Digital supply voltage for
IO pads and voltage
regulators
V
DDP SR
4.5
5.5
V
Digital ground voltage
V
SS SR
0
V
1) To ensure the stability of the voltage regulators the EVRs must be buffered with ceramic capacitors. Separate
buffer capacitors with the recomended values shall be connected as close as possible to each
V
DDIM and VDDI1
pin to keep the resistance of the board tracks below 2 Ohm. Connect all
V
DDI1 pins together. The minimum
capacitance value is required for proper operation under all conditions (e.g. temperature). Higher values
slightly increase the startup time.
2) Use one Capacitor for each pin.
3) This is the reference load. For bigger capacitive loads, use the derating factors listed in the PAD properties
section.
4) The timing is valid for pin drivers operating in default current mode (selected after reset). Reducing the output
current may lead to increased delays or reduced driving capability (
C
L).
5) The operating frequency range may be reduced for specific device types. This is indicated in the device
designation (...FxxL). 80 MHz devices are marked ...F80L.
6) Overload conditions occur if the standard operating conditions are exceeded, i.e. the voltage on any pin
exceeds the specified range:
V
OV > VIHmax (IOV > 0) or VOV < VILmin ((IOV < 0). The absolute sum of input
overload currents on all pins may not exceed 50 mA. The supply voltages must remain within the specified
limits. Proper operation under overload conditions depends on the application. Overload conditions must not
occur on pin XTAL1 (powered by
V
DDIM).
7) An overload current (
I
OV) through a pin injects a certain error current (IINJ) into the adjacent pins. This error
current adds to the respective pins leakage current (
I
OZ). The amount of error current depends on the overload
current and is defined by the overload coupling factor
K
OV. The polarity of the injected error current is inverse
compared to the polarity of the overload current that produces it.The total current through a pin is |
I
TOT| = |IOZ|
+ (|
I
OV| KOV). The additional error current may distort the input voltage on analog inputs.
8) Value is controlled by on-chip regulator
Table 13
Operating Conditions (cont’d)
Parameter
Symbol
Values
Unit
Note /
Test Condition
Min.
Typ.
Max.
相關PDF資料
PDF描述
SAK-XC2785X-72F80L 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
SAK-XC2785X-104F80L 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
SAF-XC2786X-96F66L66 32-BIT, FLASH, MICROCONTROLLER, PQFP144
SAF-XC2786X-96F80L66 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
SAF-XC886-6FFA5V 8-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP48
相關代理商/技術參數
參數描述
SAF-XC2786X-96F66L 制造商:Infineon Technologies AG 功能描述:
SAF-XC822-1FRA 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit Single-Chip Microcontroller
SAF-XC822-1FRA AA 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
SAF-XC822-1FRI 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit Single-Chip Microcontroller
SAF-XC822-1FRI AA 功能描述:8位微控制器 -MCU 8-Bit Single Chip Microcontroller RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT