- 您現在的位置：買賣IC網 > PDF目錄384892 > RX5003 (RF Monolithics, Inc.) 303.825 MHz Hybrid Receiver PDF資料下載
參數資料
| 型號： | RX5003 |
| 廠商： | RF Monolithics, Inc. |
| 英文描述： | 303.825 MHz Hybrid Receiver |
| 中文描述： | 303.825兆赫混合接收機 |
| 文件頁數： | 7/11頁 |
| 文件大?。?/td> | 103K |
| 代理商： | RX5003 |
Peak Detector Timing
The Peak Detector attack time constant is set by the value of the ca-
pacitor at the PKDET pin. The attack time t
PKA
= C
PKD
/4167, where
t
PKA
is in μs and C
PKD
is in pF. The Peak Detector decay time con-
stant t
PKD
= 1000*t
PKA
.
Pulse Generator Timing
In the low data rate mode, the interval t
PRI
between the falling edge
of an ON pulse to the first RF amplifier and the rising edge of the
next ON pulse to the first RF amplifier is set by a resistor R
PR
be-
tween the PRATE pin and ground. The interval can be adjusted be-
tween 0.1 and 5 μs with a resistor in the range of 51 K to 2000 K.
The value of the R
PR
is given by:
R
PR
= 404* t
PRI
+ 10.5, where t
PRI
is in μs, and R
PR
is in kilohms
In the high data rate mode (selected at the PWIDTH pin) the re-
ceiver RF amplifiers operate at a nominal 50%-50% duty cycle. In
this case, the period t
PRC
from the start of an ON pulse to the first
RF amplifier to the start of the next ON pulse to the first RF amplifier
is controlled by the PRATE resistor over a range of 0.1 to 1.1 μs us-
ing a resistor of 11 K to 220 K. In this case R
PR
is given by:
R
PR
= 198* t
PRC
- 8.51, where t
PRC
is in μs and R
PR
is in kilohms
In the low data rate mode, the PWIDTH pin sets the width of the ON
pulse to the first RF amplifier t
PW1
with a resistor R
PW
to ground (the
ON pulse width to the second RF amplifier t
PW2
is set at 1.1 times
the pulse width to the first RF amplifier in the low data rate mode).
The ON pulse width t
PW1
can be adjusted between 0.55 and 1 μs
with a resistor value in the range of 200 K to 390 K. The value of
R
PW
is given by:
R
PW
= 404* t
PW1
- 18.6, where t
PW1
is in μs and R
PW
is in kilohms
However, when the PWIDTH pin is connected to Vcc through a 1 M
resistor, the RF amplifiers operate at a nominal 50%-50% duty cy-
cle, facilitating high data rate operation. In this case, the RF amplifi-
ers are controlled by the PRATE resistor as described above.
LPF Group Delay
The low-pass filter group delay is a function of the filter 3 dB band-
width, which is set by a resistor R
LPF
to ground at the LPFADJ pin.
The minimum 3 dB bandwidth f
LPF
= 1445/R
LPF
, where f
LPF
is in kHz,
and R
LPF
is in kilohms.
The maximum group delay t
FGD
= 1750/f
LPF
= 1.21*R
LPF
, where t
FGD
is in μs, f
LPF
in kHz, and R
LPF
in kilohms.
7
相關PDF資料 |
PDF描述 |
|---|---|
| RX5005H | Designed for Short-Range Wireless Control and Data Communications |
| RX5500 | 433.92 MHz Hybrid Receiver |
| RX5RL20A | VOLTAGE REGULATOR |
| RXC101 | Multi-channel High data rate Programmable |
| S08A60 | SCHOTTKY BARRIER RECTIFIERS(8A,30-60V) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RX5005H | 制造商:RF Monolithics (RFM) 功能描述:433.42 MHZ HYBRID RECEIVER - Tape and Reel |
| RX500-6 | 制造商:NTE 制造商全稱:NTE Electronics 功能描述:ECG Cleaner/Lubricant |
| RX-500G | 制造商:PANASONIC INDUSTRIAL AUTOMATION SALES 功能描述:SENSOR PHOTO 500MM 12-24VDC NPN 制造商:Panasonic Electric Works 功能描述:Proximity Sensor Photoelectric Light ON/Dark ON NPN 50cm 12V to 24V |
| RX-500G-C5 | 制造商:PANASONIC ELECTRIC WORKS - ACSD 功能描述:SENSOR PHOTO 500MM 12-24VDC NPN 制造商:PANASONIC INDUSTRIAL AUTOMATION SALES 功能描述:SENSOR PHOTO 500MM 12-24VDC NPN |
| RX5029 | 制造商:Apex Tool Group 功能描述:RETURN SPRING SCREW FOR WTC400C HYDRAULIC SOFT CABLE CUTTER |
發布緊急采購，3分鐘左右您將得到回復。