參數資料
型號: Q67101-H5173-A701
廠商: SIEMENS AG
英文描述: DDC-PLUS-Deflection Controller
中文描述: DDC的加偏轉控制器
文件頁數: 20/39頁
文件大?。?/td> 199K
代理商: Q67101-H5173-A701
SDA 9362
Semiconductor Group
20
1998-02-01
PONRES:
Power On Reset
0:
after bus master has read the status byte
1:
after each detected reset
Note:
PONRES is reset after this byte has been read.
2.5.5
Start Vertical Scan
If enabled (SSE = 1) this control item defines the start of calculation of the vertical
sawtooth, the east/west parabola and the vertical function required for the vertical
modulated output HD.
Explanation of Some Control Items
Vertical Scan
(width0 and width1)
The total width of this control item is 10 Bit. Therefore two (width0 and width1) registers
are necessary. If enabled (STE = 1) it defines the duration of the vertical scan. When the
vertical period has more lines than the sum of
Start Vertical Scan
and
Vertical Scan
,
the calculation of the vertical sawtooth, the east/west parabola and the vertical parabola
required for HD stops so that the corresponding output signals remain unchanged till the
next vertical synchron pulse.
Guard Band
This control item is useful for optimizing self adaptation. Video signals with different
number of lines in consecutive fields (e. g. VCR search mode) must not start the
procedure of self adaptation. But switching between different TV standards has to
change the slope of the vertical sawtooth getting always the same amplitude (self
adaptation).
To avoid problems with flicker free TV systems which have alternating number of lines
per field an average value of four consecutive fields is calculated. If the deviation of these
average values (e.g. PAL: 312.5 lines or 625 half lines) is less or equals
Guard Band
,
no adaptation takes place. When it exceeds
Guard Band
, the vertical slope will be
changed.
Start Reduced Scan
If enabled (SRSE = 1) this item defines the start of the D/A-conversion of the calculated
vertical sawtooth. From begin of the vertical flyback to the line defined by
Start Reduced
Scan
the output signals VD+, VD- remain unchanged (flyback level). Other outputs are
not affected.
a) control bits VR1, VR0 # 00 (reduction of vertical size)
In this case the byte is useful for e.g. displaying 16/9 source format on 4/3 picture
tubes without visible RGB lines generated of the automatic cut-off control (partial
相關PDF資料
PDF描述
Q67101-H6788 ICs for Communications
Q67101-H6789 ICs for Communications
Q67101-H6790 ICs for Communications
Q67101-H6791 ICs for Communications
Q67101-H5190 SRC-Scan Rate Converter SDA9255
相關代理商/技術參數
參數描述
Q67101-H5185-A704 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:ADC with Built in Antialiasing filter and Clock generation UnitS
Q67101-H5190 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:SRC-Scan Rate Converter SDA9255
Q67101-H5193 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Picture Processor
Q67101-H6773 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Joint Audio Decoder-Encoder
Q67101-H6788 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:ICs for Communications