- 您現在的位置：買賣IC網 > PDF目錄188959 > N3476TD370 (WESTCODE SEMICONDUCTORS LTD) 6787 A, 3700 V, SCR PDF資料下載
參數資料
| 型號： | N3476TD370 |
| 廠商： | WESTCODE SEMICONDUCTORS LTD |
| 元件分類： | 晶閘管 |
| 英文描述： | 6787 A, 3700 V, SCR |
| 文件頁數： | 5/11頁 |
| 文件大小： | 211K |
| 代理商： | N3476TD370 |
WESTCODE
WESTCODE An IXYS Company
Phase Control Thyristor Types N3476T#360 to N3476T#420
Data Sheet. Types N3476T#360 to N3476T#420 Issue 1
Page 3 of 11
May, 2004
Notes on Ratings and Characteristics
1.0 Voltage Grade Table
Voltage Grade
VDRM VDSM VRRM
V
VRSM
V
VD VR
DC V
36
3600
3700
2160
37
3700
3800
2220
38
8800
3900
2280
40
4000
4100
2400
42
4200
4300
2520
2.0 Extension of Voltage Grades
This report is applicable to other voltage grades when supply has been agreed by Sales/Production.
3.0 De-rating Factor
A blocking voltage de-rating factor of 0.13%/°C is applicable to this device for Tj below 25°C.
4.0 Repetitive dv/dt
Standard dv/dt is 1000V/s.
5.0 Snubber Components
When selecting snubber components, care must be taken not to use excessively large values of snubber
capacitor or excessively small values of snubber resistor. Such excessive component values may lead to
device damage due to the large resultant values of snubber discharge current. If required, please consult
the factory for assistance.
6.0 Rate of rise of on-state current
The maximum un-primed rate of rise of on-state current must not exceed 300A/s at any time during turn-
on on a non-repetitive basis. For repetitive performance, the on-state rate of rise of current must not
exceed 150A/s at any time during turn-on. Note that these values of rate of rise of current apply to the
total device current including that from any local snubber network.
7.0 Gate Drive
The nominal requirement for a typical gate drive is illustrated below. An open circuit voltage of at least 30V
is assumed. This gate drive must be applied when using the full di/dt capability of the device.
IGM
IG
tp1
4A/s
The magnitude of IGM should be between five and ten times IGT, which is shown on page 2. Its duration
(tp1) should be 20s or sufficient to allow the anode current to reach ten times IL, whichever is greater.
Otherwise, an increase in pulse current could be needed to supply the necessary charge to trigger. The
‘back-porch’ current IG should remain flowing for the same duration as the anode current and have a
magnitude in the order of 1.5 times IGT.
相關PDF資料 |
PDF描述 |
|---|---|
| N3476TD380 | 6787 A, 3800 V, SCR |
| N3476TD400 | 6787 A, 4000 V, SCR |
| N3476TD420 | 6787 A, 4200 V, SCR |
| N3476TT360 | 6787 A, 3600 V, SCR |
| N3476TT370 | 6787 A, 3700 V, SCR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| N3480B1EB1S | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:Silicon Power Rectifier Assemblies Plate Heatsink |
| N3480B1EN1S | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:Silicon Power Rectifier Assemblies Plate Heatsink |
| N3480C1EB1S | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:Silicon Power Rectifier Assemblies Plate Heatsink |
| N3480C1EN1S | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:Silicon Power Rectifier Assemblies Plate Heatsink |
| N3480D1EB1S | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:Silicon Power Rectifier Assemblies Plate Heatsink |
發布緊急采購，3分鐘左右您將得到回復。