- 您現在的位置：買賣IC網 > PDF目錄188955 > MX53L06402L-50 (MACRONIX INTERNATIONAL CO LTD) FLASH 2.7V PROM CARD, XMA7 PDF資料下載
參數資料
| 型號： | MX53L06402L-50 |
| 廠商： | MACRONIX INTERNATIONAL CO LTD |
| 元件分類： | PROM |
| 英文描述： | FLASH 2.7V PROM CARD, XMA7 |
| 封裝： | CRAD-7 |
| 文件頁數： | 19/55頁 |
| 文件大?。?/td> | 262K |
| 代理商： | MX53L06402L-50 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁
26
P/N: PM1043
REV. 1.0, NOV. 25, 2003
MX53L06402
6.9.3 Read ahead in Stream and multiple block read operation
In stream, or multiple block, read operations, in order to avoid data under-run condition or improve read performance,
the card may fetch data from the memory array, ahead of the host. In this case, when the host is reading the last
addresses of the memory, the card attempts to fetch data beyond the last physical memory address and generates
an OUT_OF_RANGE error.
Therefore, even if the host times the stop transmission command to stop the card immediately after the last byte of
data was read, The card may already have generated the error, and it will show in the response to the stop transmission
command. The host should ignore this error.
6.10 Reset
After power-on by the host, all cards (including the cards having been in Inactive State) are in MultiMediaCard mode
(as opposed to SPI mode) and in Idle State.
Command GO_IDLE_STATE (CMD0) is the software reset command and sets all cards into Idle State. It is also used
to switch the card into SPI mode (see also "Chapter 7.5.1 Mode Selection" for more details).
After power-on or CMD0, all cards’ output bus drivers are in an high-impedance state and the cards are initialized
with a default relative card address ("0x0001" and with a default driver stage register setting (lowest speed, highest
driving current capability). The host clocks the bus at the identification clock rate fOD (see also "Chapter 9.2 Power
On" for more details).
CMD0 is valid in all states with the exception of the Inactive State. While in Inactive state the card will not accept CMD0
unless it is used to switch the card into SPI mode.
相關PDF資料 |
PDF描述 |
|---|---|
| MX574AKCWI-T | Industry-Standard, 12-Bit ADC with Reference |
| MX574AKEQI-T | Industry-Standard, 12-Bit ADC with Reference |
| MX574AKP-T | Industry-Standard, 12-Bit ADC with Reference |
| MX574ALCWI-T | Industry-Standard, 12-Bit ADC with Reference |
| MX574ALP-T | Industry-Standard, 12-Bit ADC with Reference |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MX54-3 | 功能描述:CUTTER SIDE OVAL FLUSH 4.25" RoHS:是 類別:工具 >> 切割機 系列:STUSA 標準包裝:1 系列:Xcelite® 類型:側面（對角） 形狀:錐形 切邊:凹槽 長度 - 總體:5.00"（127mm） 特點:安全夾 容量:20 AWG 軟線 重量:0.2 磅（90.72g） |
| MX-543/U | 制造商:Kings Electronics 功能描述: |
| MX54-9 | 功能描述:CUTTER SIDE OVAL FLUSH 4.25" RoHS:是 類別:工具 >> 切割機 系列:STUSA 標準包裝:1 系列:Xcelite® 類型:側面（對角） 形狀:錐形 切邊:凹槽 長度 - 總體:5.00"（127mm） 特點:安全夾 容量:20 AWG 軟線 重量:0.2 磅（90.72g） |
| MX54S30J | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MX-550-PSU | 制造商:Maxxtro 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。