- 您現在的位置：買賣IC網 > PDF目錄296642 > MT47H64M16HR-3IT 64M X 16 DDR DRAM, 0.4 ns, PBGA84 PDF資料下載
參數資料
| 型號： | MT47H64M16HR-3IT |
| 元件分類： | DRAM |
| 英文描述： | 64M X 16 DDR DRAM, 0.4 ns, PBGA84 |
| 封裝： | 8 X 12.50 MM, ROHS COMPLIANT, FBGA-84 |
| 文件頁數： | 26/129頁 |
| 文件大?。?/td> | 9252K |
| 代理商： | MT47H64M16HR-3IT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁
3. Minimum CKE high time is tCKE = 3 × tCK. Minimum CKE LOW time is tCKE = 3 × tCK.
This requires a minimum of three clock cycles of registration.
4. If this command is a PRECHARGE (or if the device is already in the idle state), then the
power-down mode shown is precharge power-down, which is required prior to the
clock frequency change.
Reset
CKE Low Anytime
DDR2 SDRAM applications may go into a reset state anytime during normal operation.
If an application enters a reset condition, CKE is used to ensure the DDR2 SDRAM de-
vice resumes normal operation after reinitializing. All data will be lost during a reset
condition; however, the DDR2 SDRAM device will continue to operate properly if the
following conditions outlined in this section are satisfied.
The reset condition defined here assumes all supply voltages (VDD, VDDQ, VDDL, and
VREF) are stable and meet all DC specifications prior to, during, and after the RESET op-
eration. All other input balls of the DDR2 SDRAM device are a “Don’t Care” during
RESET with the exception of CKE.
If CKE asynchronously drops LOW during any valid operation (including a READ or
WRITE burst), the memory controller must satisfy the timing parameter tDELAY before
turning off the clocks. Stable clocks must exist at the CK, CK# inputs of the DRAM be-
fore CKE is raised HIGH, at which time the normal initialization sequence must occur
(see Initialization). The DDR2 SDRAM device is now ready for normal operation after
the initialization sequence. Figure 79 (page 122) shows the proper sequence for a RE-
SET operation.
1Gb: x4, x8, x16 1.55V DDR2 SDRAM
Reset
PDF: 09005aef82b91d01
1GbDDR2_1_55V.PDF Rev. A 5/09 EN
121
Micron Technology, Inc. reserves the right to change products or specifications without notice.
2009 Micron Technology, Inc. All rights reserved.
相關PDF資料 |
PDF描述 |
|---|---|
| MT48H8M16LFB4-8IT:JTR | 8M X 16 SYNCHRONOUS DRAM, 6 ns, PBGA54 |
| MT48LC4M32TG-10 | 4M X 32 SYNCHRONOUS DRAM, 7 ns, PDSO54 |
| MT48V8M16LFB4-8XT | 8M X 16 SYNCHRONOUS DRAM, 7 ns, PBGA54 |
| MT48LC4M32LFB5-10ES:G | 4M X 32 SYNCHRONOUS DRAM, 7 ns, PBGA90 |
| MT48V4M32TG-8XT | 4M X 32 SYNCHRONOUS DRAM, 7 ns, PDSO54 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT47H64M16HR-3L | 制造商:MICRON 制造商全稱:Micron Technology 功能描述:DDR2 SDRAM |
發布緊急采購，3分鐘左右您將得到回復。