參數資料
型號： MAX9597CTI+
廠商： Maxim Integrated Products
文件頁數： 7/32頁
文件大?。?/td> 0K
描述： IC AUD/VID INTERACE 28TQFN-EP
產品培訓模塊： Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝： 60
類型： 音頻/視頻接口
應用： DVD，機頂盒
安裝類型： 表面貼裝
封裝/外殼： 28-WFQFN 裸露焊盤
供應商設備封裝： 28-TQFN-EP（5x5）
包裝： 托盤
MAX9597
Low-Power Audio/Video Interface
for Single SCART Connectors
______________________________________________________________________________________
15
Video Reconstruction Filter
The video DAC outputs of the set-top box decoder chip
need to be lowpass-filtered to reject the out-of-band
noise. The MAX9597 integrates sixth-order, Butterworth
filters. The filter passband (±1dB) is typically 10MHz,
and the attenuation at 27MHz is 43dB. The filters are
suited for standard-definition video.
Video Outputs
The video output amplifiers can both source and sink
load current, allowing output loads to be DC- or
AC-coupled. The amplifier output stage needs approxi-
mately 300mV of headroom from either supply rail.
If the supply voltage is greater than 3.135V (5% below
a 3.3V supply), each amplifier can drive two DC-cou-
pled video loads to ground. If the supply is less than
3.135V, each amplifier can drive only one DC-coupled
or AC-coupled video load.
The SCART standard allows for video signals to have a
superimposed DC component within 0V and 2V.
Therefore, most video signals are DC-coupled at the out-
put. In the unlikely event that the video signal needs to
be AC-coupled, the coupling capacitors should be
220F or greater to keep the highpass filter formed by
the 37.5 equivalent resistance of the video transmis-
sion line to a corner frequency of 4.8Hz or below to keep
it well below the 25Hz frame rate of the PAL standard.
The video outputs can be enabled or disabled by bits 1
to 5 of register 0Dh. See Table 11.
Slow Switching
The MAX9597 supports the IEC 933-1, Amendment 1,
trilevel slow-switching standard that selects the aspect
ratio for the display (TV). Under I2C control, the
MAX9597 sets the slow-switching output voltage level.
Table 2 shows the valid input levels of the slow-switch-
ing signal and the corresponding operating modes of
the display device.
One port is available for slow-switching signals for the
TV. The slow-switching outputs can be set to a logic
level or high impedance by writing to bit 0 and 1 of reg-
ister 07h. See Table 9.
VIDEO ORIGIN
FORMAT
VOLTAGE RANGE
(V)
COUPLING
INPUT CIRCUIT CONFIGURATION
External
CVBS
Unknown
AC
Transparent sync-tip clamp
External
RGB
Unknown
AC
Transparent sync-tip clamp
External
Y
Unknown
AC
Transparent sync-tip clamp
External
C
Unknown
AC
Bias circuit
Internal
CVBS
0 to 1
DC
Transparent sync-tip clamp
Internal
R, G, B
0 to 1
DC
Transparent sync-tip clamp
Internal
Y, C
0 to 1
DC
Transparent sync-tip clamp
Internal
Y, Pb, Pr
0 to 1
DC
Transparent sync-tip clamp
Internal
CVBS
2.3 to 3.3
AC
Transparent sync-tip clamp
Internal
R, G, B
2.3 to 3.3
AC
Transparent sync-tip clamp
Internal
Y
2.3 to 3.3
AC
Transparent sync-tip clamp
Internal
C
2.3 to 3.3
AC
Bias circuit
Table 1. Recommended Coupling for Incoming Video Signals and Input Circuit
Configuration**
**
Use a 0.1F capacitor to AC-couple a video signal into the MAX9597.
SLOW-SWITCHING
SIGNAL VOLTAGE
(V)
MODE
0 to 2
Display device uses an internal
source such as a built-in tuner to
provide a video signal.
4.5 to 7.0
Display device uses a video signal
from the SCART connector and sets
the display to a 16:9 aspect ratio.
9.5 to 12.6
Display device uses a signal from the
SCART connector and sets the
display to a 4:3 aspect ratio.
Table 2. Slow-Switching Modes
相關PDF資料
PDF描述
MAX9602EUG+T IC COMPARATOR HS 24-TSSOP
MAX9646EUK+T IC COMPARATOR W/REF SOT23-5
MAX9648AXK+T IC COMPARATOR GP SGL SC70-5
MAX964EEE+T IC COMPARATOR BTR 16-QSOP
MAX964EEE IC COMP BEYOND-RAILS QUAD 16QSOP
相關代理商/技術參數
參數描述
MAX9597CTI+ 功能描述:視頻 IC A/V Switch for Dual SCART Connector RoHS:否 制造商:Fairchild Semiconductor 工作電源電壓:5 V 電源電流:80 mA 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-28 封裝:Reel
MAX9597CTI+T 功能描述:視頻 IC A/V Switch for Dual SCART Connector RoHS:否 制造商:Fairchild Semiconductor 工作電源電壓:5 V 電源電流:80 mA 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-28 封裝:Reel
MAX9597EVKIT+ 功能描述:視頻 IC 開發工具 MAX9597 Eval Kit RoHS:否 制造商:Texas Instruments 產品:Evaluation Boards 類型:YPbPr to RGBHV Converters 工具用于評估:LMH1251 工作電源電壓:5 V
MAX9598CTL+ 功能描述:視頻開關 IC A/V Switch for Dual SCART Connector RoHS:否 制造商:Texas Instruments 開關數量:4 開啟電阻（最大值）:12 Ohms 傳播延遲時間: 開啟時間（最大值）: 關閉時間（最大值）: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:WQFN-42 封裝:Reel
MAX9598CTL+T 功能描述:視頻開關 IC A/V Switch for Dual SCART Connector RoHS:否 制造商:Texas Instruments 開關數量:4 開啟電阻（最大值）:12 Ohms 傳播延遲時間: 開啟時間（最大值）: 關閉時間（最大值）: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:WQFN-42 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*