參數資料
型號： M95320-WDW6TG
廠商： NUMONYX
元件分類： PROM
英文描述： 4K X 8 FLASH 2.7V PROM, PDSO8
封裝： 0.169 INCH, ROHS COMPLIANT, TSSOP-8
文件頁數： 11/45頁
文件大?。?/td> 440K
代理商： M95320-WDW6TG
M95320, M95640, M95320-x, M95640-x
Instructions
The protection features of the device are summarized in Table 2.
When the Status Register Write Disable (SRWD) bit of the Status Register is 0 (its initial
delivery state), it is possible to write to the Status Register provided that the Write Enable
Latch (WEL) bit has previously been set by a Write Enable (WREN) instruction, regardless
of the whether Write Protect (W) is driven High or Low.
When the Status Register Write Disable (SRWD) bit of the Status Register is set to 1, two
cases need to be considered, depending on the state of Write Protect (W):
●
If Write Protect (W) is driven High, it is possible to write to the Status Register provided
that the Write Enable Latch (WEL) bit has previously been set by a Write Enable
(WREN) instruction.
●
If Write Protect (W) is driven Low, it is not possible to write to the Status Register even
if the Write Enable Latch (WEL) bit has previously been set by a Write Enable (WREN)
instruction. (Attempts to write to the Status Register are rejected, and are not accepted
for execution). As a consequence, all the data bytes in the memory area that are
software protected (SPM) by the Block Protect (BP1, BP0) bits of the Status Register,
are also hardware protected against data modification.
Regardless of the order of the two events, the Hardware Protected Mode (HPM) can be
entered:
●
by setting the Status Register Write Disable (SRWD) bit after driving Write Protect (W)
Low
●
or by driving Write Protect (W) Low after setting the Status Register Write Disable
(SRWD) bit.
The only way to exit the Hardware Protected Mode (HPM) once entered is to pull Write
Protect (W) High.
If Write Protect (W) is permanently tied High, the Hardware Protected Mode (HPM) can
never be activated, and only the Software Protected Mode (SPM), using the Block Protect
(BP1, BP0) bits of the Status Register, can be used.
Table 5.
Protection modes
W
Signal
SRWD
Bit
Mode
Write Protection of the
Status Register
Memory Content
Protected Area(1)
1.
As defined by the values in the Block Protect (BP1, BP0) bits of the Status Register, as shown in Table 2.
Unprotected
Area(1)
10
Software
Protected
(SPM)
Status Register is Writable
(if the WREN instruction
has set the WEL bit)
The values in the BP1 and
BP0 bits can be changed
Write Protected
Ready to accept
Write instructions
00
11
01
Hardware
Protected
(HPM)
Status Register is
Hardware write protected
The values in the BP1 and
BP0 bits cannot be
changed
Write Protected
Ready to accept
Write instructions
相關PDF資料
PDF描述
MA-191 MALE, RIGHT ANGLE TWO PART BOARD CONNECTOR, CRIMP; SOLDER, PLUG
MA-1A1 FEMALE, RIGHT ANGLE TWO PART BOARD CONNECTOR, CRIMP; SOLDER, RECEPTACLE
MA142ATX 0.1 A, SILICON, SIGNAL DIODE
MA206 0.1 A, 2 ELEMENT, SILICON, SIGNAL DIODE
MA27P010G SILICON, PIN DIODE
相關代理商/技術參數
參數描述
M95320-WDW6TG/P 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:32 Kbit serial SPI bus EEPROMs with high-speed clock
M95320-WDW6TG/PC 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:32 Kbit serial SPI bus EEPROMs with high-speed clock
M95320WDW6TP 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:32 Kbit and 64 Kbit serial SPI bus EEPROMs with high-speed clock
M95320-WDW6TP 功能描述:電可擦除可編程只讀存儲器 2.5 V to 5.5V 32k RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8
M95320-WDW6TP/P 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:32 Kbit serial SPI bus EEPROMs with high-speed clock
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*