- 您現在的位置：買賣IC網 > PDF目錄48737 > LV5050V 1 A SWITCHING CONTROLLER, 1100 kHz SWITCHING FREQ-MAX, PDSO20 PDF資料下載
參數資料
| 型號： | LV5050V |
| 元件分類： | 穩壓器 |
| 英文描述： | 1 A SWITCHING CONTROLLER, 1100 kHz SWITCHING FREQ-MAX, PDSO20 |
| 封裝： | 0.225 INCH, SSOP-20 |
| 文件頁數： | 7/7頁 |
| 文件大?。?/td> | 91K |
| 代理商： | LV5050V |
LV5050V
PS No.A0000-7/7
SANYO Semiconductor Co.,Ltd. assumes no responsibility for equipment failures that result from using
products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition
ranges, or other parameters) listed in products specifications of any and all SANYO Semiconductor Co.,Ltd.
products described or contained herein.
SANYO Semiconductor Co.,Ltd. strives to supply high-quality high-reliability products, however, any and all
semiconductor products fail or malfunction with some probability. It is possible that these probabilistic failures or
malfunction could give rise to accidents or events that could endanger human lives, trouble that could give rise
to smoke or fire, or accidents that could cause damage to other property. When designing equipment, adopt
safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not
limited to protective circuits and error prevention circuits for safe design, redundant design, and structural
design.
Upon using the technical information or products described herein, neither warranty nor license shall be granted
with regard to intellectual property rights or any other rights of SANYO Semiconductor Co.,Ltd. or any third
party. SANYO Semiconductor Co.,Ltd. shall not be liable for any claim or suits with regard to a third party's
intellctual property rights which has resulted from the use of the technical information and products mentioned
above.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed
for volume production.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for the
SANYO Semiconductor Co.,Ltd. product that you intend to use.
In the event that any or all SANYO Semiconductor Co.,Ltd. products described or contained herein are
controlled under any of applicable local export control laws and regulations, such products may require the
export license from the authorities concerned in accordance with the above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system, or otherwise,
without the prior written consent of SANYO Semiconductor Co.,Ltd.
Continued from preceding page.
Pin No.
Pin name
Description
15
FB
Feed back input pin. The minus terminal (-) of the trans conductance amplifier is connected.
The voltage generated when the output voltage was divided by a resistor is input into this pin.
The converter operates so that this pin becomes an internal reference voltage (VREF=0.836V).
Also, this pin is monitored by the comparators UVP and OVP.
When the voltage of this pin becomes less than 87% of the set voltage, the PGOOD pin is low level.
A timer of the UV_DELAY function operates. Also, when the voltage of this pin becomes more than 117% of the set voltage,
the IC latches off.
16
COMP
The pin to connect a capacitor and a resistor for phase compensation.
The output of an internal transformer conductance amplifier is connected.
Connect an external phase compensation circuit between this pin and SGND.
17
SGND
The system ground of the IC. The reference voltage is generated based on this pin.
This pin is connected to the power supply system ground.
18
VDD
Power supply pin for the gate drive of an external lower-side MOS-FET.
This pin is connected to the VLIN5 pin through a filter.
19
LDRV
The gate drive pin of an external lower-side MOS-FET.
This pin has the signal input part for prevention of short-through of both the upper and lower MOS-FETs.
When the voltage of this pin becomes less than 1V, the HDRV pin is turned on.
20
PGND
Power ground pin. This pin becomes the return current path of the LDRV pin.
This catalog provides information as of December, 2008. Specifications and information herein are subject
to change without notice.
相關PDF資料 |
PDF描述 |
|---|---|
| LV8019V | BRUSH DC MOTOR CONTROLLER, 5 A, PDSO16 |
| LW30-01 | 3-OUTPUT 31 W AC-DC REG PWR SUPPLY MODULE |
| LW30-11 | 3-OUTPUT 31 W AC-DC REG PWR SUPPLY MODULE |
| LX1681IDMT | 1 A SWITCHING CONTROLLER, 230 kHz SWITCHING FREQ-MAX, PDSO8 |
| LX1682IDMT | 1 A SWITCHING CONTROLLER, 230 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LV5050V-TLM-E | 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| LV5051T-TLM-E | 制造商:ON Semiconductor 功能描述:DC-DC CONVERTER (BUCK) - Tape and Reel 制造商:ON Semiconductor 功能描述:REEL / DC-DC CONVERTER (BUCK) |
| LV5052V | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:DC/DC Converter Controller |
| LV5052V-MPB-E | 功能描述:DC/DC 開關控制器 RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| LV5052V-TLM-E | 功能描述:DC/DC 開關控制器 DC / DC CONVERTER RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
發布緊急采購，3分鐘左右您將得到回復。