- 您現在的位置：買賣IC網 > PDF目錄11575 > LTC4258CGW#PBF (Linear Technology)IC POE 802.3AF QUAD 36-SSOP PDF資料下載
參數資料
| 型號： | LTC4258CGW#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 19/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC POE 802.3AF QUAD 36-SSOP |
| 產品培訓模塊： | Power over Ethernet |
| 標準包裝： | 32 |
| 控制器類型： | 以太網供電控制器（POE） |
| 接口： | IEEE 802.3af |
| 電源電壓： | 3 V ~ 4 V |
| 電流 - 電源： | 2.5mA |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 36-BSOP（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 36-SSOP |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC4258
26
4258fb
APPLICATIO S I FOR ATIO
WU
UU
Common Mode Chokes
Both nonpowered and powered Ethernet connections
achieve best performance (for data transfer, power trans-
fer and EMI) when a common mode choke is used on each
port. In the name of cost reduction, some designs share a
common mode choke between two adjacent ports. Even
for nonpowered Ethernet, sharing a choke is not recom-
mended. With two ports passing through the choke, it
cannot limit the common mode current of either port.
Instead, the choke only controls the sum of both ports’
common mode current. Because cabling from the ports
generally connects to different devices up to 200m apart,
a current loop can form. In such a loop, common mode
current flows in one port and out the other, and the choke
will not prevent this because the sum of the currents is
zero. Another way to view this interaction between the
paired ports is that the choke acts as a transformer
coupling the ports’ common modes together. In
nonpowered Ethernet, common mode current results
from nonidealities like ground loops; it is not part of
normal operation. However, Power over Ethernet sends
power and hence significant current through the ports;
common mode current is a byproduct of normal opera-
tion. As described in the Choosing External MOSFETs
section and under the Power Supplies heading below,
large transients can occur when a port’s power is turned
on or off. When a powered port is shorted (see Surge
Suppressors and Circuit Protection), a port’s common
mode current may be excessive. Sharing a common mode
choke between two ports couples start-up, disconnect
and fault transients from one port to the other. The end
result can range from momentary noncompliance with
802.3af to intermittent behavior and even to excessive
voltages that may damage circuitry (in both the PSE and
PD) connected to the ports.
Detect Pin Diodes
During detection and classification, the LTC4258 senses
the port voltage through the detect diodes DDET. Excessive
voltage drop across DDET will corrupt the LTC4258’s
detect and classification results. Select a diode for DDET
that will have less than 0.7V of forward drop at 0.4mA and
less than 0.9V of forward drop at 50mA.
Power Supplies
The LTC4258 must be supplied with 3.3V (VDD) and
–48V (VEE). Poor regulation on either of these supplies
can lead to noncompliance. The IEEE requires a PSE
output voltage between 44V and 57V. When the LTC4258
begins powering an Ethernet port, it controls the current
through the port to minimize disturbances on VEE. How-
ever, if the VEE supply is underdamped or otherwise
unstable, its voltage could go outside of the IEEE specified
limits, causing all ports in the PSE to be noncompliant.
This scenario can be even worse when a PD is unplugged
because the current can drop immediately to zero. In both
cases the port voltage must always stay between –44V
and –57V. In addition, the 802.3af specification places
specific ripple, noise and load regulation requirements on
the PSE. Among other things, disturbances on either VDD
or VEE can adversely affect detection and classification
sensing. Proper bypassing and stability of the VDD and VEE
supplies is important.
Another problem that can affect the VEE supply is insuffi-
cient power, leading to the supply voltage drooping out of
the specified range. The 802.3af specification states that
if a PSE powers a PD it must be able to provide the
maximum power level requested by the PD based on the
PD’s classification. The specification does allow a PSE to
choose not to power a port because the PD requires more
power than the PSE has left to deliver. If a PSE is built with
a VEE supply capable of less than 15.4W (number of
PSE’s Ethernet ports), it must implement a power alloca-
tion algorithm that prevents ports from being powered
when there is insufficient power. Because the specifica-
tion also requires the PSE to supply 400mA at up to a 5%
duty cycle, the VEE supply capability should be at least a
few percent more than the maximum total power the PSE
will supply to PDs. Finally, the LTC4258s draw current
from VEE. If the VDD supply is generated from VEE, that
power divided by the switcher efficiency must also be
added to the VEE supply’s capability.
Fast VEE transients can damage the LTC4258. Limit the
VEE slew rate to 50mV/
s. In most applications, existing
VEE bypass capacitors will cause the VEE supply to slew
much slower than 50mV/
s.
相關PDF資料 |
PDF描述 |
|---|---|
| PIC16C54CT-04/SO | IC MCU OTP 512X12 18SOIC |
| 000-53150 | CONN PLUG 11/16 TRIAXIAL RG58/A |
| PIC16LC620A-04I/SS | IC MCU OTP 512X14 COMP 20SSOP |
| PIC16C620A-04E/P | IC MCU OTP 512X14 COMP 18DIP |
| PIC16F726-E/SO | IC PIC MCU FLASH 8KX14 28-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC4259A | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Power over Ethernet IEEE 802.3af PD Interface with Integrated Switching Regulator |
| LTC4259A-1 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Synchronous No-Opto Flyback Controller |
| LTC4259ACGW | 功能描述:IC CTRLR POE QUAD AC DISC 36SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:2,450 系列:- 控制器類型:SPI 總線至 I²C 總線橋接 接口:I²C，串行，SPI 電源電壓:2.4 V ~ 3.6 V 電流 - 電源:11mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-HVQFN（4x4） 包裝:托盤 配用:568-3511-ND - DEMO BOARD SPI TO I2C 其它名稱:935286452157SC18IS600IBSSC18IS600IBS-ND |
| LTC4259ACGW#PBF | 功能描述:IC CTRLR POE QUAD AC DISC 36SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:2,450 系列:- 控制器類型:SPI 總線至 I²C 總線橋接 接口:I²C，串行，SPI 電源電壓:2.4 V ~ 3.6 V 電流 - 電源:11mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-HVQFN（4x4） 包裝:托盤 配用:568-3511-ND - DEMO BOARD SPI TO I2C 其它名稱:935286452157SC18IS600IBSSC18IS600IBS-ND |
| LTC4259ACGW#TR | 功能描述:IC CTRLR POE QUAD AC DISC 36SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:2,450 系列:- 控制器類型:SPI 總線至 I²C 總線橋接 接口:I²C，串行，SPI 電源電壓:2.4 V ~ 3.6 V 電流 - 電源:11mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-HVQFN（4x4） 包裝:托盤 配用:568-3511-ND - DEMO BOARD SPI TO I2C 其它名稱:935286452157SC18IS600IBSSC18IS600IBS-ND |
發布緊急采購，3分鐘左右您將得到回復。