
LA6504H
PS No.A0594-10/10
SANYO Semiconductor Co.,Ltd. assumes no responsibility for equipment failures that result from using
products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition
ranges, or other parameters) listed in products specifications of any and all SANYO Semiconductor Co.,Ltd.
products described or contained herein.
SANYO Semiconductor Co.,Ltd. strives to supply high-quality high-reliability products, however, any and all
semiconductor products fail or malfunction with some probability. It is possible that these probabilistic failures or
malfunction could give rise to accidents or events that could endanger human lives, trouble that could give rise
to smoke or fire, or accidents that could cause damage to other property. When designing equipment, adopt
safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not
limited to protective circuits and error prevention circuits for safe design, redundant design, and structural
design.
Upon using the technical information or products described herein, neither warranty nor license shall be granted
with regard to intellectual property rights or any other rights of SANYO Semiconductor Co.,Ltd. or any third
party. SANYO Semiconductor Co.,Ltd. shall not be liable for any claim or suits with regard to a third party's
intellctual property rights which has resulted from the use of the technical information and products mentioned
above.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed
for volume production.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for the
SANYO Semiconductor Co.,Ltd. product that you intend to use.
In the event that any or all SANYO Semiconductor Co.,Ltd. products described or contained herein are
controlled under any of applicable local export control laws and regulations, such products may require the
export license from the authorities concerned in accordance with the above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system, or otherwise,
without the prior written consent of SANYO Semiconductor Co.,Ltd.
Sample Application Circuit
Cautions for use
1. GND
The center frame (FR) functions as a power system GND. Set it to the minimum potential together with S-GND.
2. Bypass capacitor
For power supply, connect the bypass capacitor immediately near the pin of this IC.
3. Lightening, ground fault, and short-circuit between outputs
Avoid short-circuit between the output pin and power supply (lightening), short-circuit between the output pin and
GND (ground fault), and short-circuit between output pins (load short-circuit). When mounting IC to the substrate,
pay attention to the direction of IC. Mounting in the wrong direction may cause damage to IC, and fuming in certain
cases.
This catalog provides information as of February, 2007. Specifications and information herein are subject
to change without notice.
28
27
26
25
24
23
22
21
20
19
18
17
16
15
1
2
3
4
5
6
7
8
9
10
11
12
13
14
SLED
MOTOR
FOCUS
COIL
TRACKING
COIL
LOADING
MOTOR
MUTE
TRACK IN
FOCUS
LOADING
or
SLED
1.75V
12V
M