- 您現在的位置：買賣IC網 > PDF目錄11585 > KSZ8841-16MBL (Micrel Inc)IC MAC CTLR 1PORT ETH 100-LBGA PDF資料下載
參數資料
| 型號： | KSZ8841-16MBL |
| 廠商： | Micrel Inc |
| 文件頁數： | 11/105頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MAC CTLR 1PORT ETH 100-LBGA |
| 標準包裝： | 260 |
| 控制器類型： | 以太網控制器，MAC |
| 接口： | 總線 |
| 電源電壓： | 3.1 V ~ 3.5 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 100-LBGA |
| 供應商設備封裝： | 100-LFBGA |
| 包裝： | 托盤 |
| 產品目錄頁面： | 1080 (CN2011-ZH PDF) |
| 其它名稱： | 576-3075 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁
Micrel, Inc.
KSZ8841-16/32 MQL/MVL/MBL
October 2007
13
M9999-102207-1.6
Pin Number
Pin Name
Type
Pin Function
15
SRDYN
Opu
Synchronous Ready Not
Ready signal to interface with synchronous bus for both EISA-like and VLBus-like extend
accesses.
For VLBus-like mode, the falling edge of this signal indicates ready. This signal is
synchronous to the bus clock signal BCLK.
For burst mode (32-bit interface only), the KSZ8841M drives this pin low to signal wait
states.
16
INTRN
Opd
Interrupt
Active Low signal to host CPU to indicate an interrupt status bit is set, this pin need an
external 4.7K pull-up resistor.
17
LDEVN
Opd
Local Device Not
Active Low output signal, asserted when AEN is Low and A15-A4 decode to the
KSZ8841M address programmed into the high byte of the base address register. LDEVN
is a combinational decode of the Address and AEN signal.
18
RDN
Ipd
Read Strobe Not
Asynchronous read strobe, active Low.
19
EECS
Opu
EEPROM Chip Select
This signal is used to select an external EEPROM device.
20
ARDY
Opd
Asynchronous Ready
ARDY may be used when interfacing asynchronous buses to extend bus access cycles. It
is asynchronous to the host CPU or bus clock. this pin need an external 4.7K pull-up
resistor.
21
CYCLEN
Ipd
Cycle Not
For VLBus-like mode cycle signal; this pin follows the addressing cycle to signal the
command cycle.
For burst mode (32-bit interface only), this pin stays High for read cycles and Low for write
cycles.
22
NC
Opd
No Connect
23
DGND
Gnd
Digital IO ground
24
VDDCO
P
1.2V digital core voltage output (internal 1.2V LDO power supply output), this 1.2V output
pin provides power to VDDC, VDDA and VDDAP pins. It is recommended this pin should
be connected to 3.3V power rail by a 100 ohm resistor for the internal LDO application
Note: Internally generated power voltage. Do not connect an external power supply to this
pin. This pin is used for connecting external filter (Ferrite bead and capacitors).
25
VLBUSN
Ipd
VLBus-like Mode
Pull-down or float: Bus interface is configured for synchronous mode.
Pull-up: Bus interface is configured for 8-bit or 16-bit asynchronous mode or EISA-like
burst mode.
26
EEEN
Ipd
EEPROM Enable
EEPROM is enabled and connected when this pin is pull-up.
EEPROM is disabled when this pin is pull-down or no connect.
27
P1LED3
Opd
Port 1 LED indicator
See the description in pins 3, 4, and 5.
28
EEDO
Opd
EEPROM Data Out
This pin is connected to DI input of the serial EEPROM.
29
EESK
Opd
EEPROM Serial Clock
A 4
s (OBCR[1:0]=11 on-chip bus speed @ 25 MHz) or 800 ns (OBCR[1:0]=00 on-chip
bus speed @ 125 MHz) serial output clock cycle to load configuration data from the serial
EEPROM.
相關PDF資料 |
PDF描述 |
|---|---|
| PIC12LCE518-04I/SM | IC MCU OTP 512X12 LV W/EE 8-SOIJ |
| PIC12CE519T-04/SN | IC MCU OTP 1KX12 W/EE 8SOIC |
| KSZ8841-16MQL | IC MAC CTRLR 8/16BIT 128-PQFP |
| PIC12CE518-04E/SM | IC MCU OTP 512X12 W/EE 8-SOIC |
| KSZ8895RQ | IC 10/100-T 5 PORT SW 128PQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8841-16MBL-EVAL | 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:Single-Port Ethernet MAC Controller with Non-PCI Interface |
| KSZ8841-16MBLI | 功能描述:以太網 IC 10/100BT Ethernet MAC + PHY with Generic (8, 16-Bit) Bus Interface (I-Temp) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8841-16MQL | 功能描述:以太網 IC Single Ethernet Port + Generic (8, 16-bit) bus interface( Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8841-16MQL A6 | 功能描述:IC MAC CTRLR 8/16BIT 128-PQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
| KSZ8841-16MQL-EVAL | 功能描述:以太網開發工具 KSZ8841-16MQL Evaluation Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: |
發布緊急采購，3分鐘左右您將得到回復。