- 您現在的位置：買賣IC網 > PDF目錄385344 > GS9023 (Electronic Theatre Controls, Inc.) Embedded Audio CODEC PDF資料下載
參數資料
| 型號： | GS9023 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 元件分類： | Codec |
| 英文描述： | Embedded Audio CODEC |
| 中文描述： | 嵌入式音頻編解碼器 |
| 文件頁數： | 21/33頁 |
| 文件大小： | 301K |
| 代理商： | GS9023 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
GENNUM CORPORATION
522 - 45 - 05
21
G
Control Code Output
In the non-AES/EBU output formats, the V, U and C bits are
output separately from the audio data stream. The bits are
output respectively to the VFLA/B, UDA/B and CSA/B pins
according to the channel pair to which they belong and
change state on the rising edge of WCOUT. The SAFA/B
output pins are set to HIGH for one audio frame out of 192
frames to mark the start of a block. In the AES/EBU audio
output format, the respective pins are not used.
Detection of Audio Packets
The GS9023 can demultiplex up to four audio channels of
an audio group. The audio group (Audio packet data ID) for
each device is configured in
“
AD20ID[3:0]
”
of Host
Interface Register #3h. When the corresponding audio
packets are found on the active video line, the GS9023 sets
the respective
“
CHACT(4-1)
”
bits of Host Interface
Register #1h. If no corresponding audio packets are found
on the active video line, the
“
CHACT(4-1)
”
bits are set LOW.
By connecting four GS9023 devices in parallel, it is
possible to demultiplex up to 16 audio channels in a
component video signal as shown in Figure 19. On power
up, audio group 1 is selected by default.
Detection of Extended Audio Packets
The GS9023 can demultiplex 20 or 24 bit audio samples.
For 24 bit audio samples, the 20 MSBs of a 24 bit audio
sample are contained in the audio data packets and the 4
LSBs are contained in an extended audio data packet as
defined in SMPTE 272. The audio group (Extended packet
data ID) for each device is configured in
“
AD4ID[3:0]
”
of
Host Interface Register #3h. When the corresponding
extended audio packets are detected on the active video
stream, the GS9023 sets the AUXEN pin and the
“
A4ON
”
bit
of Host Interface Register #1h to HIGH. If no corresponding
extended audio packets are found on the active video line,
the AUXEN pin and
“
A4ON
”
bit are set to LOW. On power
up, audio group 1 extended audio packets are selected by
default.
Detection of Audio Control Packets
The audio group (Audio control packet data ID) for each
device is configured in
“
ACID[3:0]
”
of Host Interface
Register #4h. When the configured ID is detected on the
designated video lines (see Table 6), the
“
ACON
”
bit of
Host Interface Register #1h is set. The corresponding Audio
control
parameters
are
stored
Registers #Ah, #Bh, #Ch and #Dh. If an audio control
packet is not detected or found in non-designated video
lines,
“
ACON
”
is set to LOW. However, the information in the
audio control packets found in non-designated lines is
considered valid and is stored in Host Interface Registers
#Ah, #Bh, #Ch and #Dh. On power up, audio group 1 audio
control packets are selected by default.
in
Host
Interface
Detection and Output of Arbitrary Data Packets
The GS9023 is capable of demultiplexing arbitrary data
packets according to SMPTE 291M. There are no limitations
on the number of packets that can be demultiplexed and
the packets can be located outside of the vertical blanking
interval (VBI).
The arbitrary data packet data ID is configured in
PKTID[7:0] of Host Interface Register #5h. When the
configured ID is detected in the active video or HANC area,
data on the PKT[8:0] pins is clocked out on the rising edge
of PCLK. The GS9023 sets the PKTEN output pin HIGH,
when the data at the PKT[8:0] outputs is valid. PKTEN is set
LOW when the last user data word (UDW) is output from
PKT[8:0]. Figure 13 shows the output timing.
Fig. 13: Arbitrary Data Output Timing Diagram
Error Detection
The GS9023 provides error status information in Host
Interface Registers #7h, #8h and #9h as described in Table
15. Register #7 contains error information on audio
sampling and CRC conditions. Register #8 contains error
information on audio packet data block number and data
count. Register #9 contains error information on Control
packets. Errors are cleared when the respective Host
Interface Register is read.
PCLK (I)
PKTEN (O)
PKT[8:0] (O)
Valid data
NOTE: 1 - The ancillary data flag, ADF, is one word in composite systems (ANSI/SMPTE 259M)
and three words in component systems (ANSI/SMPTE 125M).
A
1
S
D
X
X
X
X
X
X
X
C
A
1
A
1
D
1 clk
相關PDF資料 |
PDF描述 |
|---|---|
| GS9023-CFY | Aluminum Electrolytic Radial Leaded Bi-Polar Capacitor; Capacitance: 100uF; Voltage: 63V; Case Size: 12.5x20 mm; Packaging: Bulk |
| GS9024 | Automatic Cable Equalizer |
| GS9024-CKB | Automatic Cable Equalizer |
| GS9024-CTB | Automatic Cable Equalizer |
| GS9032-CTME3 | GENLINX-TM II GS9032 Digital Video Serializer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GS9023A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SD Embedded Audio CODEC |
| GS9023ACFY | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:GENLINX -TM II GS9023A Embedded Audio CODEC |
| GS9023ACFYE3 | 制造商:Semtech Corporation 功能描述:Audio Codec 4ADC / 4DAC 24-Bit 100-Pin LQFP |
| GS9023B | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:Embedded Audio CODEC |
| GS9023BCVE3 | 功能描述:IC AUDIO CODEC 100PIN TQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 編解碼器 系列:- 標準包裝:2,500 系列:- 類型:立體聲音頻 數據接口:串行 分辨率（位）:18 b ADC / DAC 數量:2 / 2 三角積分調變:是 S/N 比，標準 ADC / DAC (db):81.5 / 88 動態范圍，標準 ADC / DAC (db):82 / 87.5 電壓 - 電源，模擬:2.6 V ~ 3.3 V 電壓 - 電源，數字:1.7 V ~ 3.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-WFQFN 裸露焊盤 供應商設備封裝:48-TQFN-EP（7x7） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。