
ePVP6200
VFD Controller
This specification is subject to change without further notice.
11.18.2004 (V1.53)
17 of 57
Bit 7 (IDLE)
:
SLEEP or IDLE mode control as set by SLEP instruction.
0/1
SLEEP mode/IDLE mode.
This bit allows SLEP instruction to decide which power saving mode to
execute. The status after wake-up and the wake-up source list is as the shown
below.
Wakeup Signal
SLEEP Mode
IDLE Mode
RA(7,6)=(0,0)
+ SLEP
RA(7,6)=(1,0)
+ SLEP
1) Wake-up
2) Jump to next instruction after SLEP
1) Wake-up
2) Jump to next instruction after SLEP
1) Wake-up
2) Jump to next instruction after SLEP
1) Wake-up
2) Jump to next instruction after SLEP
1) Wake-up
2) Jump to next instruction after SLEP
1) Wake-up
2) Jump to next instruction after SLEP
1) Wake-up
2) Jump to next instruction after SLEP
1) Wake-up
2) Next instruction
1) Wake-up
2) Jump to next instruction after SLEP
1) Wake-up
2) Jump to next instruction after SLEP
TCC time out
IOCF Bit0=1
COUNTER1 time out
IOCF Bit1=1
COUNTER2 time out
IOCF Bit2=1
COUNTER3 time out
IOCD Bit0=1
COUNTER4 time out
IOCD Bit1=1
COUNTER5 time out
IOCD Bit2=1
PORT90(IR function)
IOCF Bit3=1
No function
No function
No function
No function
No function
No function
Reset and jump
to Address 0
WDT time out
Reset and jump
to Address 0
PORTC(0~3)(Key1~Key4)
RE PAGE0 Bit3 or Bit4 or Bit5 or Bit6 = 1
PORT9(1~4)
IOCF Bit4 or Bit5 or Bit6 =1 or Bit7=1
Reset and Jump
to Address 0
Reset and Jump
to Address 0
NOTES:
1 PORT90 wakeup function is controlled by IOCF Bit 3. It is a falling edge or rising edge
trigger (controlled by CONT register Bit7).
2. PORT91 wakeup function is controlled by IOCF Bit 4. It is a falling edge trigger.
3. PORT92 ~ PORT94 wakeup functions are controlled by IOCF. They are falling edge
triggers.
4. PORTC0 ~ PORTC3 wakeup functions are controlled by RE PAGE0 Bit 0 ~ Bit 3. They are
falling edge triggers.