參數資料
型號： CY8CLED16P01-28PVXI
廠商： CYPRESS SEMICONDUCTOR CORP
元件分類： 微控制器/微處理器
英文描述： SPECIALTY MICROPROCESSOR CIRCUIT, PDSO28
封裝： 0.210 INCH, LEAD FREE, SSOP-28
文件頁數： 58/58頁
文件大?。?/td> 837K
代理商： CY8CLED16P01-28PVXI
CY8CLED16P01
Document Number: 001-49263 Rev. *J
Page 9 of 58
Equations 2 and 3 are used to determine how many digital blocks
are needed by a DSPWM. The total dimming resolution of a
DSPWM modulator is the total of the hardware PWM modulation
resolution and extra resolution added by Delta Sigma modulation
in the software. Equation 3 shows that the number of digital
blocks needed is only determined by the hardware resolution.
These equations show that more dimming resolution is achieved
with a DSPWM modulator than with a PWM or PrISM modulator.
A DSPWM modulator requires more code space and execution
time to use.
Equations 1, 2, and 3 determine the number of digital blocks
required by one modulator. The total number of blocks for all
modulators is determined by adding up the digital blocks needed
by each modulator used in the device.
The CY8CLED16P01 device has a variety of LED dimming
configurations. Because it has 16 digital blocks, it can implement
eight 16-bit PWM modulators, eight 12-bit PrISM modulators, or
sixteen 12-bit DSPWM modulators (assuming the software
resolution is 4 bits). As another example, it can implement four
10-bit PrISM modulators and still have 8 digital blocks left over
to implement other digital functions.
The CY8CLED16P01 is a one-device solution for powerline
communication and HB LED control. For an application that runs
powerline communication and HB LED control simultaneously,
the
CY8CLED16P01
can
implement
four
16-bit
PWM
modulators, four 12-bit PrISM modulators, or eight 12-bit
DSPWM modulators (assuming the software resolution is 4 bits).
3.2 Color Mixing Algorithm
Code algorithms to implement color mixing functionality work
well with EZ-Color controllers. Color mixing algorithms convert a
set of color coordinates that specify a color into the appropriate
8-bit dimming values for the LED dimming modulators. This
enables the EZ-Color controller to be communicated on a higher
level and maintain desired color and brightness levels.
The basic 3-channel color mixing firmware performing 8-bit LED
dimming requires three 8-bit dimming blocks. The discussion on
LED dimming modulation implies that it consumes three digital
blocks. The addition of a simple temperature compensation
algorithm using a thermistor consumes an additional digital block
and analog block (for the ADC).
If the dimming resolution is increased, the number of digital
blocks needed should be calculated accordingly.
3.3 LED Temperature Compensation
Many HB LED systems need to measure analog signals. One or
more thermistors are often present to measure temperatures of
the system and the LEDs. The CY8CLED16P01 measures an
analog signal with an analog-to-digital converter (ADC). The
device can implement a variety of flexible ADC implementations.
The ADCs cover a wide range of resolutions and techniques and
use varied number of digital and analog block resources. For help
in selecting from this multitude of ADCs, refer to application note
AN2239, Analog – ADC Selection on http://www.cypress.com.
When designing with an EZ-Color device, the number of digital
and analog blocks used by an ADC must be factored into the total
number of digital and analog blocks that are used.
In a typical case, such as the 3-channel color mixing firmware IP
developed by Cypress, the simple 8-bit incremental ADC is used.
This module occupies one digital and one switched capacitor
analog block.
Analog blocks come in two types: continuous time and switched
capacitor blocks. The former enables continuous time functions
such as comparators and programmable gain amplifiers. The
switched capacitor blocks enable functions such as ADCs and
filters.
Temperature sensors with an I2C interface can also be used
instead of raw thermistors, thereby eliminating the need for
ADCs and complicated processing.
3.4 ColorLock Algorithm
ColorLock functionality uses feedback from an optical sensor in
the system to adjust the LED dimming modulators correctly to
“l(fā)ock on” to a target color. This is similar to the concept of temper-
ature compensation because it compensates for change in color.
Instead of indirectly measuring change in color through temper-
ature, it senses actual change in color and compensates for it.
The ColorLock algorithm implemented by Cypress requires the
use of 10 digital blocks. Due to a 9-bit PrISM implementation, 6
digital blocks are used for dimming as in Equation 1. A 16-bit
PWM and two 8-bit timers are also used to form the frame
generator, pulse counter, and debounce counter.
Equation 2
8
HW
DSPWM
n
DigBlocks
Equation 3
HW
SW
Total
n
相關PDF資料
PDF描述
CYW2332BCI PLL FREQUENCY SYNTHESIZER, 1200 MHz, QCC24
CYW255OXC 255 SERIES, LOW SKEW CLOCK DRIVER, 24 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO48
CYW256OXCT 256 SERIES, LOW SKEW CLOCK DRIVER, 12 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO28
D01-9970121 SIP1, IC SOCKET
D01-9974842 SIP48, IC SOCKET
相關代理商/技術參數
參數描述
CY8CLED16P01-28PVXIT 功能描述:LED照明片上系統- SoC PROGRAMMABLE W/EZ 32K FLASH 2K RAM RoHS:否 類型:Power Programmable SoC Power Controllers 最大時鐘頻率:48 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 數據 ROM 大小:2 KB 接口:API, DALI, DMX512, I2C, SPI, UART, USB 可編程輸入/輸出端數量:14 片上 ADC:6 x 12-bit 片上 DAC:6 x 8-bit 電源電流:16 mA 電源電壓:7 V to 32 V 封裝 / 箱體:QFN-56 封裝:Tray 制造商:Cypress Semiconductor 核心:M8C 數據總線寬度:8 bit 程序存儲器類型:Flash 定時器數量:8 x 32-bit 高電平輸出電流:10 mA 低電平輸出電流:25 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT
CY8CLED16P01-48LFXI 功能描述:LED照明片上系統- SoC 32 KB 2048 B RoHS:否 類型:Power Programmable SoC Power Controllers 最大時鐘頻率:48 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 數據 ROM 大小:2 KB 接口:API, DALI, DMX512, I2C, SPI, UART, USB 可編程輸入/輸出端數量:14 片上 ADC:6 x 12-bit 片上 DAC:6 x 8-bit 電源電流:16 mA 電源電壓:7 V to 32 V 封裝 / 箱體:QFN-56 封裝:Tray 制造商:Cypress Semiconductor 核心:M8C 數據總線寬度:8 bit 程序存儲器類型:Flash 定時器數量:8 x 32-bit 高電平輸出電流:10 mA 低電平輸出電流:25 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT
CY8CLED16P01-48LTXI 功能描述:可編程片上系統 - PSoC PROGRAMMABLE W/EZ 32K FLASH 2K RAM RoHS:否 制造商:Cypress Semiconductor 核心:8051 處理器系列:CY8C36 數據總線寬度:8 bit 最大時鐘頻率:67 MHz 程序存儲器大小:32 KB 數據 RAM 大小:4 KB 片上 ADC:Yes 工作電源電壓:0.5 V to 5.5 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:QFN-68 安裝風格:SMD/SMT
CY8CLED16P01-48LTXIT 功能描述:可編程片上系統 - PSoC Powerline Comm Sol 32K Flash 2K Ram RoHS:否 制造商:Cypress Semiconductor 核心:8051 處理器系列:CY8C36 數據總線寬度:8 bit 最大時鐘頻率:67 MHz 程序存儲器大小:32 KB 數據 RAM 大小:4 KB 片上 ADC:Yes 工作電源電壓:0.5 V to 5.5 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:QFN-68 安裝風格:SMD/SMT
CY8CLEDAC01 功能描述:LED照明驅動器 EZ Color RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*