參數資料
型號： CS5124DR8
英文描述： Current-Mode SMPS Controller
中文描述： 電流模式開關電源控制器
文件頁數： 2/16頁
文件大?。?/td> 184K
代理商： CS5124DR8
CS51220
http://onsemi.com
10
The block diagram of the soft hiccup circuit is shown in
Figure 5. When overcurrent occurs and the SS is above 2.9 V,
the OC pulses set the OC latch. The output of the OC latch
turns on the OC delay discharge current to ramp down the SS
voltage. This SS discharge ramp down is at a rate of 50
A
while the SS voltage is above 2.8 V. The level between 2.9 V
and 2.8 V is called the hiccup delay discharge voltage. The
time to cross this voltage creates a short delay. This delay is
useful so that a quick transient overcurrent condition can be
controlled and still allow the supply to return immediately to
normal operation. After reaching the hiccup delay discharge
voltage, the SS current is reduced to 5.0
A and the ISET
foldback current is turned on at 15
A. It is the ISET
foldback current that adjusts the ISET level to establish a
new lower ISENSE current limit level. See Figure 6 for
details.
Figure 5. The Block Diagram of the Soft
Hiccup Operation
SS low
CLK
OC
SS
+
–
One Shot
N00C
Reset
Peak COMP
2.9 V
Trig
OC Latch
Delay COMP
2.8 V
SS
Discharge
ON
S
R
Foldback
Q
A circuit monitors the OC pulses. If the OC pulses cease
for 50
s, the NOt–OverCurrent (NOOC) signal is
generated. This NOOC signal resets the OC Latch and
allows the SS capacitor to charge back up allowing the
output to reestablish regulation.
For an equivalent circuit shown in Figure 6, the ISET
current reduces the overcurrent threshold and sets the new
threshold at
VI(SET) + (3.3 * ISET
R1)
R2
(R1
) R2)
VREF
ISET Pin
R1
R2
ISET
Figure 6. The Voltage Divider Used at the ISET
Pin Allows the ISET Foldback Current to
Reduce the Overcurrent Threshold
The NOOC or SS low (VSS < 0.3 V) signal can reset OC
latch at any time. This event turns off ISET foldback and
allows the recharging of the SS capacitor. Therefore, the IC
allows the power supply to restart periodically or after the
overcurrent condition is cleared. The OC latch can not be set
until the SS capacitor is fully charged.
To implement “hard hiccup” which disables the VO
completely when the SS voltage is ramping down, select a
resistor value greater than 3.3 V/ISET for R1 in Figure 6, and
saturate the internal ISET current source. Since the saturation
voltage is less than the DC shift applied to the ISENSE signal,
the OC comparator output is always high and in turn keeps
the VO low. Figure 7 demonstrates the interactions among
the voltage of SS, ISET and internal signal OC. Figure 8
further describes the specifications associated with the soft
hiccup. The ratio among the charge time, delay time and
discharge time is given at the bottom of Figure 8.
SS
ISET
OC
50
s
2.9 V
2.8 V
0.3 V
Figure 7. Illustrative Waveforms of the
Soft Hiccup Operation
Charge Voltage
Charge
Current
Figure 8. The SS Pin Voltage Under Ramp
Up and Overcurrent Condition and
Associated Specifications.
26
Discharge Voltage
OC Delay
Dischage
Current
Dischage
Current
1
250
Hiccup Delay
Discharge Voltage
相關PDF資料
PDF描述
CS5126D8 Current-Mode SMPS Controller
CS5126DR8 Current-Mode SMPS Controller
CS-5127 Dual Output Non-Synchronous Buck Controller with Sync Function and Secon
CS-5127DW16 Current-Mode SMPS Controller
CS-5127DWR16 Current-Mode SMPS Controller
相關代理商/技術參數
參數描述
CS5124XD8 功能描述:電流型 PWM 控制器 Hi Performance RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
CS5124XD8G 功能描述:電流型 PWM 控制器 Hi Performance Current Mode PWM RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
CS5124XDR8 功能描述:電流型 PWM 控制器 Hi Performance RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
CS5124XDR8G 功能描述:電流型 PWM 控制器 Hi Performance Current Mode PWM RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
CS5126-KL 制造商:Rochester Electronics LLC 功能描述: 制造商:Cirrus Logic 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*