詳細信息
(1) Vibration Test振動試驗
To be no interference in operation after vibrations, 10Hz to 50Hz for 2 ho-urs full amplitude 1.52mm ,the sensitivity to be within ±3dB from initial sens-itivity，the measurement should be done after 3 hours at the room temperature.
將沒有操作干擾過的咪頭，在10HZ到50HZ、1.52 mm全振幅下振動 30分鐘后，試驗后在常溫下放置3小時后測試，靈敏度變化在±3dB內。
(2) Drop Test跌落試驗
The microphone without packaged must be subjected to each 3 drops at three axises from
theheight of 120cm to 2cm thick hardwood board, the sensitivity to be within ±3dB from initial
sensitivity，the measurement should be done after 3 hours at the room temperature.
不帶包裝的咪頭經過從3個不同的軸面從120厘米的高度下落到2厘米厚的硬質木板上，試驗后在常溫下放置3小時后測試，靈敏度變化在±3dB內。
(3) High Temperature Test高溫試驗
To be no interference in operation after high temperature test 70±3℃ for 48 hours. The
sensitivity to be within ±3dB from initial sensitivity, the mea-surement should be done after 3 hours at the room temperature.
將沒有操作干擾過的咪頭在70±3℃高溫下試驗48小時，試驗后在常溫下放置3小時后測試，靈敏度變化在±3dB內。
(4) Isotherm & ISO-humidity Test恒溫恒濕試驗
To be no interference in operation after storage test at temperature 55±3℃ and relative
humidity (95±3%) for 48 hours, the sensitivity to be within ±3dB from initial sensitivity, the
measurement should be done after 3 hours at the room temperature.
將沒有操作干擾過的咪頭在溫度55±3℃、相對濕度95±3%的環境下試驗48小時，試驗后在常溫下放置3小時后測試，靈敏度變化在±3dB內 。
(5) Low Temperature Test 低溫試驗
To be no interference in operation after Low temperature test -25±3℃ for 48 hours, the sensitivity to be within ±3dB from initial sensitivity，the meas-urement should be done after 3 hours at the room temperature.
將沒有操作干擾過的咪頭在-25±3℃的低溫環境下放置48小時，試驗后在常溫下放置3小時后測試，靈敏度變化在±3dB內 。
(6) Temperature Cycle Test溫度循環試驗
To be no interference in operation after exposure at +65±2℃ for 0.5 hour,
at 20±2℃ for 1 hour, at 25±2℃ for 0.5 hour, at 20±2℃ for 10 minutes, with 5 cycles.
The sensitivity to be within ±3dB from initial sensitivity
將沒有操作干擾過的咪頭在+65±2℃下0.5小時，后在20±2℃下10分鐘，后在-25±2℃下0.5小時，后在20±2℃下10分鐘，連續循環5次，試驗后在常溫下放置3小時后測試，靈敏度變化在±3dB內 。