- 您現在的位置：買賣IC網 > PDF目錄379828 > CDB4226 (Cirrus Logic, Inc.) Surround Sound Codec PDF資料下載
參數資料
| 型號： | CDB4226 |
| 廠商： | Cirrus Logic, Inc. |
| 元件分類： | Codec |
| 英文描述： | Surround Sound Codec |
| 中文描述： | 環繞聲編解碼器 |
| 文件頁數： | 11/60頁 |
| 文件大?。?/td> | 1619K |
| 代理商： | CDB4226 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
CS4226
DS188F1
11
Adjustable Input Gain
The signals from the line inputs are routed to a pro-
grammable gain circuit which provides up to 9 dB
of gain in 3 dB steps. The gain is adjustable
through the Input Control Byte. Right and left
channel gain settings are controlled independently
with the GNR1/0 and GNL1/0 bits. Level changes
occur immediately on register updates. To mini-
mize audible artifacts, level changes should be
done with the channel muted.
The ADC Status Report Byte provides feedback of
input level for each ADC channel. This register
continously monitors the ADC output and records
the peak output level since the last register read.
Reading this register causes it to reset to 0 and peak
monitoring begins again.
High Pass Filter
The operational amplifiers in the input circuitry
driving the CS4226 may generate a small DC offset
into the A/D converter. The CS4226 includes a
high pass filter after the decimator to remove any
DC offset which could result in recording a DC lev-
el, possibly yielding "clicks" when switching be-
tween devices in a multichannel system.
The characteristics of this first-order high pass fil-
ter are outlined Table 2 below for an output sample
rate of 44.1 kHz. This filter response scales linearly
with sample rate.
Analog Outputs
Line Level Outputs
The CS4226 contains an on-chip buffer amplifier
producing single-ended outputs capable of driving
10 k
loads. Each output (A
OUT
1-6) will produce
a nominal 2.83 Vpp (1 Vrms) output with a 2.3 volt
quiescent voltage for a full scale digital input. The
recommended off-chip analog filter is a 2nd order
Butterworth with a -3 dB corner at Fs, see Figure 3.
This filter provides out-of-band noise attenuation
along with a gain of 2, providing a 2 Vrms output
signal. A 3rd order Butterworth filter with a -3dB
corner at 0.75 Fs can be used if greater out of band
noise filtering is desired. The CS4226 DAC inter-
polation filter is a linear phase design which has
been pre-compensated for an external 2nd order
Butterworth filter to provide a flat frequency re-
sponse and linear phase response over the pass-
band. If this filter is not used, small frequency
response magnitude and phase errors will occur.
Output Level Attenuator
The DAC outputs are each routed through an atten-
uator which is adjustable in 1 dB steps. Output at-
tenuation is available through the Output
Attenuator Data Bytes. Level changes are imple-
mented in the analog domain such that the noise is
attenuated by the same amount as the signal , until
the residual output noise is equal to the noise floor
in the mute state; at this point attenation is imple-
mented in the digital domain. The change from an-
alog to digital attenuation occurs at -23 dB. Level
changes only take effect on zero crossings to mini-
mize audible artifacts. If there is no zero crossing,
then the requested level change will occur after a
time-out period between 512 and 1024 frames
(11.6 ms to 23.2 ms at 44.1 kHz frame rate). There
is a separate zero crossing detector for each chan-
nel. Each ACC bit (Acceptance bit) in the DAC
Status Report Byte gives feedback on when a vol-
ume control change has taken effect. This bit goes
high when a new setting is loaded and returns low
when it has taken effect. Volume control changes
can be instantaneous by setting the Zero Crossing
Disable (ZCD) bit in the DAC Control Byte to 1.
Each output can be independently muted via mute
control bits, MUT6-1, in the DAC Control Byte.
Frequency Response
-3dB @ 3.4 Hz
-0.13 dB @ 20 Hz
10 degrees @ 20 Hz
None
Phase Deviation
Passband Ripple
Table 2. High Pass Filter Characteristics
相關PDF資料 |
PDF描述 |
|---|---|
| CDB4228A | 24-Bit, 96 kHz Surround Sound Codec |
| CDB4228 | 24-Bit, 96 kHz Surround Sound Codec |
| CDB42416 | 110 dB, 192kHz 6-Ch CODEC WITH PLL |
| CDB42418 | 110 dB, 192kHz 8-Ch CODEC WITH PLL |
| CDB42426 | 114 dB, 192kHz 6-Ch CODEC WITH PLL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CDB4227 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Six Channel, 20-Bit Codec |
| CDB4228 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:24-Bit, 96 kHz Surround Sound Codec |
| CDB4228A | 制造商:Cirrus Logic 功能描述:Tools Development kit Kit Con |
| CDB42324 | 功能描述:音頻 IC 開發工具 Eval Bd 2-In 4-Out Mult. -Ch CODEC RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| CDB42325 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:10-In, 6-Out, 2 Vrms Audio CODEC with Headphone |
發布緊急采購，3分鐘左右您將得到回復。