參數資料
型號: CDB4222
廠商: Cirrus Logic, Inc.
元件分類: Codec
英文描述: 20-Bit Stereo Audio Codec with Volume Control
中文描述: 20帶有音量位立體聲音頻編解碼器控制
文件頁數: 10/26頁
文件大小: 580K
代理商: CDB4222
set at the input to the CS4222 will be removed
by the internal high-pass filters. See Figure 3 for
the differential input signal description. The
ADC outputs may be muted (set to zero) by
writing the ADMR and ADML bits, and the
ADC can be independently powered down using
the PDAD bit. ADMR, ADML, and PDAD are
all located in the ADC control byte (#1).
Input Level Monitoring
The CS4222 includes independent Peak Input
Level Monitoring for each channel. The analog-
to-digital converter continually monitors the peak
digital signal for both channels, prior to the digi-
tal limiter, and records these values in the
LVL2-0 (left channel) and LVR2-0 (right chan-
nel) bits in the Converter Status Report Byte
(#6). These bits indicate whether the input level
is clipping, -1 to -6 dB from full scale in 1 dB
resolution, or below -6 dB from full scale. The
LVL/LVR bits are "sticky" bits and are reset to
zero when read.
High Pass Filter
The operational amplifiers in the input circuitry
driving the CS4222 may generate a small DC
offset into the A/D converter. The CS4222 in-
cludes a high pass filter after the decimator to
remove any DC offset which could result in re-
cording a DC level, possibly yielding "clicks"
when switching between devices in a multichan-
nel system. The characteristics of this first-order
high pass filter are outlined below for Fs equal
to 48 kHz. The filter response scales linearly
with sample rate. The high pass filter may be de-
feated independently for the left and right
channels by writing HPDR and HPDL in the
ADC control byte (#1).
Frequency Response
-3dB @ 3.7 Hz
-0.1 dB @ 20 Hz
10 degrees @ 20 Hz
None
Phase Deviation
Passband Ripple
Table 2. High Pass Filter Characteristics
Analog Outputs
Line Level Outputs
The CS4222 contains an on-chip buffer amplifier
producing differential outputs capable of driving
10 k
loads. Each output (AOUTL+, AOUTL-,
AOUTR+, AOUTR-) will produce a nominal
2.83 Vpp (1 Vrms) output with a 2.3 volt com-
mon mode for a full scale digital input. This is
equivalent to a 5.66 Vpp (2 Vrms) differential
signal as shown in Figure 3. The recommended
off-chip analog filter is either a 2nd order Butter-
worth or a 3rd order Butterworth, if greater
out-of-band noise filtering is desired. The
CS4222 DAC interpolation filter has been pre-
compensated for an external 2nd order
Butterworth filter with a 3dB corner at Fs, or a
3rd order Butterworth filter with a 3dB corner at
0.75 Fs to provide a flat frequency response and
linear phase over the passband (see Figure 4 for
Fs = 48 kHz). If the recommended filter is not
used, small frequency response magnitude and
phase errors will occur. In addition to providing
out-of-band noise attenuation, the output filters
shown in Figure 4 provide differential to single-
ended conversion.
The DACs can be powered down using the
PDDA bit in the DAC control register (#2).
CS4222
AIN+/AOUT+
AIN+/AOUT-
Full Scale Output level = (AOUT+) - (AOUT-)= 5.66 Vpp
(2.3 + 1.4)V
2.3V
(2.3 - 1.4)V
(2.3 + 1.4)V
2.3V
(2.3 - 1.4)V
Full Scale Input level = (AIN+) - (AIN-)= 5.66 Vpp
Figure 3. Full Scale Input/Output Voltage
CS4222
10
DS236PP3
相關PDF資料
PDF描述
CDB4224 24-Bit 105 dB Audio Codec with Volume Control
CDB4223 24-Bit 105 dB Audio Codec with Volume Control
CDB4225 Digital Audio Conversion System
CDB4226 Surround Sound Codec
CDB4228A 24-Bit, 96 kHz Surround Sound Codec
相關代理商/技術參數
參數描述
CDB4223 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:24-Bit 105 dB Audio Codec with Volume Control
CDB4224 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:24-Bit 105 dB Audio Codec with Volume Control
CDB4225 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Digital Audio Conversion System
CDB4226 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Surround Sound Codec
CDB4227 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Six Channel, 20-Bit Codec