參數資料
型號： AD7606BSTZ
廠商： Analog Devices Inc
文件頁數： 19/36頁
文件大?。?/td> 0K
描述： IC DAS W/ADC 16BIT 8CH 64LQFP
設計資源： Layout Considerations for an Expandable Multichannel Simultaneous Sampling Data Acquisition System Based on AD7606 (CN0148)
標準包裝： 1
類型： 數據采集系統（DAS），ADC
分辨率（位）： 16 b
采樣率（每秒）： 200k
數據接口： DSP，MICROWIRE?，并聯，QSPI?，串行，SPI?
電壓電源： 模擬和數字
電源電壓： 2.3 V ~ 5.25 V，4.75 V ~ 5.25 V
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 64-LQFP
供應商設備封裝： 64-LQFP（10x10）
包裝： 托盤
AD7606/AD7606-6/AD7606-4
Data Sheet
Rev. C | Page 26 of 36
CONVERSION CONTROL
Simultaneous Sampling on All Analog Input Channels
The AD7606/AD7606-6/AD7606-4 allow simultaneous sampling
of all analog input channels. All channels are sampled simul-
taneously when both CONVST pins (CONVST A, CONVST B)
are tied together. A single CONVST signal is used to control both
CONVST x inputs. The rising edge of this common CONVST
signal initiates simultaneous sampling on all analog input channels
(V1 to V8 for the AD7606, V1 to V6 for the AD7606-6, and V1
to V4 for the AD7606-4).
The AD7606 contains an on-chip oscillator that is used to
perform the conversions. The conversion time for all ADC
channels is tCONV. The BUSY signal indicates to the user when
conversions are in progress, so when the rising edge of CONVST
is applied, BUSY goes logic high and transitions low at the end
of the entire conversion process. The falling edge of the BUSY
signal is used to place all eight track-and-hold amplifiers back
into track mode. The falling edge of BUSY also indicates that
the new data can now be read from the parallel bus (DB[15:0]),
the DOUTA and DOUTB serial data lines, or the parallel byte bus,
DB[7:0].
Simultaneously Sampling Two Sets of Channels
The AD7606/AD7606-6/AD7606-4 also allow the analog input
channels to be sampled simultaneously in two sets. This can be
used in power-line protection and measurement systems to
compensate for phase differences introduced by PT and CT
transformers. In a 50 Hz system, this allows for up to 9° of phase
compensation; and in a 60 Hz system, it allows for up to 10° of
phase compensation.
This is accomplished by pulsing the two CONVST pins
independently and is possible only if oversampling is not in use.
CONVST A is used to initiate simultaneous sampling of the
first set of channels (V1 to V4 for the AD7606, V1 to V3 for the
AD7606-6, and V1 and V2 for the AD7606-4); and CONVST B
is used to initiate simultaneous sampling on the second set of
analog input channels (V5 to V8 for the AD7606, V4 to V6 for
the AD7606-6, and V3 and V4 for the AD7606-4), as illustrated
in Figure 44. On the rising edge of CONVST A, the track-and-
hold amplifiers for the first set of channels are placed into hold
mode. On the rising edge of CONVST B, the track-and-hold
amplifiers for the second set of channels are placed into hold
mode. The conversion process begins once both rising edges
of CONVST x have occurred; therefore BUSY goes high on the
rising edge of the later CONVST x signal. In Table 3, Time t5
indicates the maximum allowable time between CONVST x
sampling points.
There is no change to the data read process when using two
separate CONVST x signals.
Connect all unused analog input channels to AGND. The results
for any unused channels are still included in the data read because
all channels are always converted.
CONVST A
CONVST B
BUSY
CS/RD
DATA: DB[15:0]
FRSTDATA
V1
V2
V3
V7
V8
t5
tCONV
V1 TO V4 TRACK-AND-HOLD
ENTER HOLD
V5 TO V8 TRACK-AND-HOLD
ENTER HOLD
AD7606 CONVERTS
ON ALL 8 CHANNELS
08479-
042
Figure 44. AD7606 Simultaneous Sampling on Channel Sets While Using Independent CONVST A and CONVST B Signals—Parallel Mode
相關PDF資料
PDF描述
AD7607BSTZ-RL IC DAS W/ADC 14BIT 8CH 64LQFP
AD7608BSTZ-RL IC DAS W/ADC 18BIT 8CH 64LQFP
AD7609BSTZ-RL IC DAS W/ADC 18BIT 8CH 64LQFP
AD760AQ IC DAC 16BIT W/AMP SRL 28-CDIP
AD766AN IC DAC 16BIT W/REF DSP 16-DIP
相關代理商/技術參數
參數描述
AD7606BSTZ 制造商:Analog Devices 功能描述:IC ADC 16BIT 200KSPS QFP-64 制造商:Analog Devices 功能描述:IC, ADC, 16BIT, 200KSPS, QFP-64
AD7606BSTZ-4 功能描述:IC DAS W/ADC 16BIT 4CH 64LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Data Converter Basics 標準包裝:1 系列:- 類型:電機控制 分辨率（位）:12 b 采樣率（每秒）:1M 數據接口:串行，并聯 電壓電源:單電源 電源電壓:2.7 V ~ 3.6 V，4.5 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:100-TQFP 供應商設備封裝:100-TQFP（14x14） 包裝:剪切帶 (CT) 其它名稱:296-18373-1
AD7606BSTZ-4 制造商:Analog Devices 功能描述:IC, ADC, 16BIT, 200KSPS, QFP-64
AD7606BSTZ-4RL 功能描述:IC DAS W/ADC 16BIT 64LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤
AD7606BSTZ-6 功能描述:IC DAS W/ADC 16BIT 6CH 64LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*